Disinfection byproduct relationships and speciation in chlorinated nanofiltered waters

The formation and speciation of disinfection byproducts (DBPs) resulting from chlorination of nanofilter permeates obtained from various source water locations and membrane types are examined. Specific ultraviolet absorbance and bromide utilization are shown to decrease following nanofiltration. Both dissolved organic carbon (DOC) concentration and ultraviolet absorbance at 254 nm were found to correlate strongly with trihalomethane (THM), haloacetic acid (HAA), and total organic halide (TOX) concentrations in chlorinated nanofilter permeates, suggesting that they can be employed as surrogates for DBPs in nanofiltered waters. Because smooth curves were obtained for individual THM and HAA species as well as bromine and chlorine incorporation into THMs and HAAs as a function of Br-/DOC molar ratio, it is likely that mole fractions of these DBPs are more strongly influenced by chlorination conditions, Br-, and DOC concentrations than NOM source and membrane type. Mole fractions of mono-, di-, and trihalogenated HAAs were found to be independent of Br-/DOC. Even at a very low Br-/DOC of 2.9microM/mM, the mixed bromochloro- and tribromoacetic acids constituted 20% of total HAAs on a molar basis. This increased to approximately 50% as Br-/DOC increased to approximately 25microM/mM or more, proving that a large fraction of HAAs may not be covered under existing federal regulations. Total THM and HAA9 concentrations decreased in permeate waters with increasing Br-/DOC suggesting that nanofilter permeates are limited with respect to DBP precursors.