Stepwise hapticity changes in sequential one-electron redox reactions of indenyl-molybdenum complexes: combined

M E Stoll1, P Belanzoni, M J Calhorda

  • 1Department of Chemistry, University of Vermont, Cook Physical Science Building, Burlington, Vermont 05405-0125, USA.

Related Concept Videos

Thermal and Photochemical Electrocyclic Reactions: Overview01:26

Thermal and Photochemical Electrocyclic Reactions: Overview

Electrocyclic reactions are reversible reactions. They involve an intramolecular cyclization or ring-opening of a conjugated polyene. Shown below are two examples of electrocyclic reactions. In the first reaction, the formation of the cyclic product is favored. In contrast, in the second reaction, ring-opening is favored due to the high ring strain associated with cyclobutene formation.
Thermal Electrocyclic Reactions: Stereochemistry01:17

Thermal Electrocyclic Reactions: Stereochemistry

The stereochemistry of electrocyclic reactions is strongly influenced by the orbital symmetry of the polyene HOMO. Under thermal conditions, the reaction proceeds via the ground-state HOMO.
Selection Rules: Thermal Activation
Conjugated systems containing an even number of π-electron pairs undergo a conrotatory ring closure. For example, thermal electrocyclization of (2E,4E)-2,4-hexadiene, a conjugated diene containing two π-electron pairs, gives trans-3,4-dimethylcyclobutene.
Photochemical Electrocyclic Reactions: Stereochemistry01:26

Photochemical Electrocyclic Reactions: Stereochemistry

The absorption of UV–visible light by conjugated systems causes the promotion of an electron from the ground state to the excited state. Consequently, photochemical electrocyclic reactions proceed via the excited-state HOMO rather than the ground-state HOMO. Since the ground- and excited-state HOMOs have different symmetries, the stereochemical outcome of electrocyclic reactions depends on the mode of activation; i.e., thermal or photochemical.
Selection Rules: Photochemical Activation
Electrophilic Aromatic Substitution: Overview01:16

Electrophilic Aromatic Substitution: Overview

In an electrophilic aromatic substitution reaction, an electrophile substitutes for a hydrogen of an aromatic compound.
Electron Paramagnetic Resonance (EPR) Spectroscopy: Organic Radicals01:17

Electron Paramagnetic Resonance (EPR) Spectroscopy: Organic Radicals

Ideally, an unpaired electron shows a single peak in the EPR spectrum due to the transition between the two spin energy states. However, coupling interactions can occur between the spins of the unpaired electron and any neighboring spin-active nuclei. This hyperfine coupling results in hyperfine splitting, where the EPR signal is split into multiplets. The signals split into 2nI + 1 peaks, where n is the number of equivalent nuclei and I is the nuclear spin. These splitting patterns provide...
Alkenes via Reductive Coupling of Aldehydes or Ketones: McMurry Reaction01:22

Alkenes via Reductive Coupling of Aldehydes or Ketones: McMurry Reaction

The radical dimerization of ketones or aldehydes gives vicinal diols through a pinacol coupling reaction. However, the behavior of titanium metals used for the reaction as a source of electrons is unusual. When the reaction is carried out in the presence of titanium, diols can be isolated at low temperatures. Else titanium further reacts with diols, forming alkenes through the McMurry reaction.