Related Experiment Videos

Bi-directional computing architecture for time series prediction

H Wakuya1, J M Zurada

  • 1Department of Electrical and Computer Engineering, University of Louisville, KY 40292, USA. wakuya@aivo.spd.louisville.edu

Related Concept Videos

Time-Series Graph00:54

Time-Series Graph

A time-series graph is a line graph with repeated measurements taken at successive intervals of time. It is also called a time series chart. To construct a time-series graph, one must look at both pieces of a paired data set. The horizontal axis is used to plot the time increments, and the vertical axis is used to plot the values of the variable that one is measuring. By using the axes in this way, each point on the graph will correspond to time and a measured quantity. The points on the graph...
Prediction Intervals01:03

Prediction Intervals

The interval estimate of any variable is known as the prediction interval. It helps decide if a point estimate is dependable.
However, the point estimate is most likely not the exact value of the population parameter, but close to it. After calculating point estimates, we construct interval estimates, called confidence intervals or prediction intervals. This prediction interval comprises a range of values unlike the point estimate and is a better predictor of the observed sample value, y. 
The...
Linear time-invariant Systems01:23

Linear time-invariant Systems

A system is linear if it displays the characteristics of homogeneity and additivity, together termed the superposition property. This principle is fundamental in all linear systems. Linear time-invariant (LTI) systems include systems with linear elements and constant parameters.
The input-output behavior of an LTI system can be fully defined by its response to an impulsive excitation at its input. Once this impulse response is known, the system's reaction to any other input can be calculated...
Linear Approximation in Time Domain01:21

Linear Approximation in Time Domain

Nonlinear systems often require sophisticated approaches for accurate modeling and analysis, with state-space representation being particularly effective. This method is especially useful for systems where variables and parameters vary with time or operating conditions, such as in a simple pendulum or a translational mechanical system with nonlinear springs.
For a simple pendulum with a mass evenly distributed along its length and the center of mass located at half the pendulum's length, the...
Directional Derivatives01:26

Directional Derivatives

In multivariable calculus, partial derivatives describe how a function changes when movement is restricted to a single coordinate direction. For a surface represented by a function of two variables, one partial derivative measures the slope in the x-direction, while the other measures the slope in the y-direction. Although these quantities are useful for analyzing local behavior, most physical motion does not occur strictly parallel to the coordinate axes. Applications such as fluid flow, heat...
Maximizing the Directional Derivative01:25

Maximizing the Directional Derivative

The directional derivative is a central concept in multivariable calculus that describes how a function changes at a given point when moving in a specified direction. This direction is represented by a unit vector, ensuring that only the orientation influences the rate of change. By varying the direction, different rates of change can be observed, demonstrating that the directional derivative depends strongly on the chosen direction.The directional derivative is computed using the gradient...