Pressure-induced amorphization and an amorphous-amorphous transition in densified porous silicon

S K Deb1, M Wilding, M Somayazulu

  • 1Solid State Physics Division, Bhabha Atomic Research Centre, Mumbai 400 085, India.

Nature
|December 6, 2001
PubMed

Related Concept Videos

States of Matter and Phase Changes00:59

States of Matter and Phase Changes

The internal energy of a substance—the total kinetic energy of all its molecules and the potential energy of their associated forces—depends on the strength of the intermolecular forces in the condensed phases and the pressure exerted on the substance. The internal energy of a substance is the highest in the gaseous state, the lowest in the solid state, and intermediate in the liquid state. Phase transitions are caused by changes in physical conditions, such as temperature and pressure, that...
Pressure of Fluids01:14

Pressure of Fluids

There are many examples of pressure in fluids in everyday life, such as in relation to blood (high or low blood pressure) and in relation to weather (high- and low-pressure weather systems). A given force can have a significantly different effect, depending on the area over which the force is exerted. For instance, a force applied to an area of 1 mm2 has a pressure that is 100 times greater than the same force applied to an area of 1 cm2. That's why a sharp needle is able to poke through skin...
Fluid Pressure01:14

Fluid Pressure

In mechanical engineering, fluid pressure plays a critical role in designing systems that utilize liquid flow, such as hydraulic systems, pumps, and valves. When designing these systems, engineers must ensure they can withstand the forces created by fluid pressure to avoid damage or failure.
According to Pascal's law, a fluid at rest will generate equal pressure in all directions. This pressure is measured as a force per unit area, and its magnitude depends on the fluid's specific weight or...
Stress Concentrations01:24

Stress Concentrations

Stress concentration is when stress intensifies near discontinuities such as holes or abrupt cross-sectional changes in a structural member. This localized stress can often surpass the average stress within the member. The stress distribution in flat bars, either with a circular hole or varying widths connected by fillets, can be determined experimentally using a photoelastic method. The results are based on ratios of geometric parameters like the ratio of the hole's radius to the smaller width...
Stress Concentrations01:13

Stress Concentrations

The concept of stress concentration is crucial for understanding how materials respond under bending stresses, particularly when there are irregularities or discontinuities in the material's geometry. Normally, stress in a symmetric member subjected to pure bending is assumed to be uniformly distributed across the entire cross-section. However, this assumption does not hold when there are variations in the cross-sectional geometry or the presence of notches and holes.
The stress concentration...
Concept of Pressure at a Point01:15

Concept of Pressure at a Point

The concept of pressure at a point in a fluid establishes that pressure within a fluid is uniform in all directions at a specific location. This uniformity occurs because fluid molecules exert force evenly across any point due to their random motion and continuous collisions within the fluid. Pressure at a point is determined by the surrounding fluid molecules and is influenced by factors like depth and density, rather than by shape or orientation.
In a fluid at rest, pressure acts equally in...