Related Experiment Video
Updated: Jul 19, 2026

Design and Construction of an Urban Runoff Research Facility
Published on: August 8, 2014
Freeze Tolerance of Seed-Producing Turf Bermudagrasses
Jeffrey A. Anderson1, Charles M. Taliaferro
1Dep. of Horticulture and Landscape Architecture, Oklahoma State Univ., Stillwater, OK 74078-6027. Dep. of Plant and Soil Sciences, Oklahoma State Univ., Stillwater, OK 74078-6027.
Abstract:
Bermudagrass, Cynodon dactylon (L.) Pers., suffers periodic severe winter-kill throughout much of its area of use in the contiguous USA. A research goal is to increase freeze tolerance in cultivars to lessen the risk of such damage. An identified research need is for Cynodon germplasm resources to be characterized for freeze tolerance and hybridization potential. Accordingly, the objective of this research was to characterize the relative freeze tolerance of selected fertile bermudagrass plants. Nine tetraploid (2n = 4x = 36) C. dactylon and two triploid (2n = 3x = 27) hybrid (C. dactylon x C. transvaalensis Burtt Davy) clonal plants (standards) were evaluated in two experiments. Plants were propagated clonally and established in Cone-tainers (Ray Leach Cone-tainer Nursery, Canby, OR) for about 10 wk. Acclimation took place for 4 wk in controlled environment chambers at 8/2 degrees C (day/night) temperatures with a 10-h photoperiod. Following acclimation, Cone-tainers were placed into a freeze chamber and cooled rapidly to -2 degrees C, induced to freeze with ice chips, then held overnight at -2 degrees C. The freeze chamber was then programmed to cool linearly at 1 degrees C per hour. For each cultivar, three Cone-tainers were removed at each test temperature. Following thawing, Cone-tainers were transferred to a greenhouse and regrowth was evaluated visually. Nonlinear regression was used to estimate T(mid), which corresponded to the midpoint of the sigmoidal response curve of survival vs temperature. Within experiment one, Tifgreen (T(mid) = -7.2 degrees C) was significantly less cold hardy than Quickstand (-9.0 degrees C), A-12204 (-9.2 degrees C), Midiron (-9.9 degrees C), and A-12195 (-10.5 degrees C). A-12195 was significantly hardier than all genotypes except Midiron. In the second experiment, Arizona Common (-6.6 degrees C), Tifgreen (-7.1 degrees C), and A-12205 (-7.1 degrees C) were less hardy than A-9959 (-8.7 degrees C), A-12156 (-8.9 degrees C), A-12198 (-9.5 degrees C), and Midiron (-10.0 degrees C). Midiron was hardier than all genotypes except A-12198. The range of test temperatures chosen did not allow estimate of a T(mid) value for Zebra, but nearly 50% of the plants were killed at -6.0 degrees C.
Related Concept Videos
Responses to Heat and Cold Stress
Masonry in Cold and Hot Weather Conditions
Other key practices include keeping masonry units and sand dry and...
Retarders
The function of retarders is to delay the setting of concrete, and this effect can be measured using a penetration test. The retardation process involves adding...
Cold Weather Concreting
To counteract the negative impacts of cold weather, ensuring...
Frost Action on Concrete
This freeze-thaw cycle primarily causes surface scaling, where...
Frost Resistant Concrete
Introducing microscopic air bubbles into the concrete mix through air entrainment creates small voids that accommodate ice expansion, thereby reducing internal pressures and preventing cracking. The optimal amount of entrained...

