Fate of atrazine and alachlor in redox-treated ferruginous smectite

The oxidation state of structural iron (Fe) in clay minerals exerts a large influence on clay surface chemistry and may affect the adsorption and degradation of pesticides in the environment. This effect, however, has been little investigated. In the present study, herbicides atrazine and alachlor were reacted with ferruginous smectite (sample SWa-1) in its oxidized, reduced (either chemically or bacterially), and reduced-reoxidized states. In some experiments the herbicide was labeled with 14C. Gas chromatography/mass spectrometry (GC-MS) was also used to detect alachlor degradation products. Compared to oxidized clays, reduction by both chemical and microbial treatments decreased the concentration of both herbicides in the surrounding solution. Reoxidized clay exhibited behavior similar to the oxidized clay. Hydrolysis-dechlorination of atrazine occurred in the presence of chemically reduced SWa-1, and GC-MS analysis of alachlor revealed at least 14 degradation products after treatment with reduced clay and only two with the oxidized clay. Interaction of atrazine and alachlor with the clay may be through a H bond with the waters of hydration surrounding interlayer cations, the extent of which should increase with increasing acidity; but under reduced conditions, the validity of this model is unclear. Reduction of structural Fe may affect pH-dependent phenomena in two ways: The increased surface charge density increases the number of hydrated interlayer cations, thereby enhancing surface acidity, and increased electron density at basal surface oxygens increases their Brønsted basicity. Atrazine could, therefore, adsorb and/or degrade through either acid or alkaline hydrolysis pathways. Increased reduction potential of the reduced clay surfaces may also promote degradation.