Related Experiment Videos
A single-step colony-forming unit assay for unseparated mobilized peripheral blood, cord blood, and bone marrow
A M de Kreuk1, A Zevenbergen, J W van Oostveen
1Department of Hematology, VU Medical Center, Amsterdam, The Netherlands.
Abstract:
The colony-forming unit (CFU) assay is exposed to a lot of variation, part of which is introduced by several enrichment strategies that are routinely performed before assessment of clonogenic capacity in mobilized peripheral blood (PB), bone marrow (BM), or cord blood (CB). We investigated the possibility to perform a single-step CFU assay by direct plating of PB, BM, or CB into CFU culture medium to obtain more reproducible results than after a standard Ficoll or lysis procedure. Direct plating implies the presence of red blood cells (RBC), white blood cells (WBC), and plasma in the CFU assay, which could possibly influence the outcome of the assay. Of all components, only the RBC was found to negatively influence CFU-GM growth if a concentration of > 0.02 x 10(9)/ml was present in the CFU culture medium. Subsequently, depending on the RBC concentration PB, BM, and CB samples were prediluted in triplicate or quadruplicate and plated into CFU medium. Lysis and/or Ficoll procedures were also performed in triplicate or quadruplicate on the same samples, and the mean colony number and coefficient of variation (CV) of the three techniques were compared. Significantly smaller CV values were found using the direct plating technique (all assays, mean 7.5%, range 1.6-15.6%) than after Ficoll separation (mean 18.0%, range 2.2-62.5%). Intermediate results were obtained with the lysis method (mean CV 11.6%, range 3.3-29%). In most samples, and especially in those with a very low number of clonogenic cells per milliliter, more colonies were detected with the direct plating method than with either the lysis or Ficoll method. In conclusion, the single-step direct plating method significantly enhances reproducibility of the CFU assay for PB, BM, and CB samples in comparison with standard techniques by circumvention of loss of colony formation and by decreasing variability. Furthermore, the direct plating technique is a timesaving assay.