Shear strength after ethylenediaminetetraacetic acid conditioning of dentin

On the basis of previous studies, it was hypothesized that a chelating agent such as ethylenediamine-tetraacetic acid (EDTA) in a saturated aqueous solution (24%) can function as a dentin conditioning agent with exposure times comparable to that of phosphoric acid without compromising shear bond strength. Thirty caries-free human third molars, divided equally between two groups, were used. In group one, four experimental surfaces were prepared on each tooth, and cylindrical copper matrixes with a diameter of 5 mm were attached to the prepared surfaces. The experimental surfaces were then treated with a 24% EDTA gel for 30, 60, 120, or 240 sec, respectively. Dentin was bonded with All Bond 2, after which a flowable composite was added and light-cured. In group two, which served as control, two surfaces were prepared on each tooth. One surface was left unetched, whereas the other side was treated with 24% EDTA-gel for 30 sec. A shear bond strength test was performed at a crosshead speed of 1 mm/min until the composite debonded. There was no statistically significant difference (P< 0.89) between results of the shear bond strength test for the different EDTA conditioning times. The control group showed a significant difference in shear bond strength between untreated surfaces and surfaces conditioned for 30 sec with EDTA. Thus, the results indicate that the duration of EDTA gel conditioning of dentin surfaces need not exceed that of phosphoric acid in clinical practice to obtain an acceptable level of bond strength.