Related Experiment Video

Updated: Oct 1, 2026

A Toolkit to Enable Hydrocarbon Conversion in Aqueous Environments
20:28

A Toolkit to Enable Hydrocarbon Conversion in Aqueous Environments

Published on: October 2, 2012

Evaporation rates of alkanes and alkanols from acoustically levitated drops

Rudolf Tuckermann1, Sigurd Bauerecker, Bernd Neidhart

  • 1Institut für Küstenforschung/Physikalische und Chemische Analytik, GKSS-Forschungszentrum Geesthacht GmbH, Germany. rudolf.tuckermann@gkss.de

Analytical and Bioanalytical Chemistry
|April 10, 2002
PubMed

More Related Videos

A High Performance Impedance-based Platform for Evaporation Rate Detection06:39

A High Performance Impedance-based Platform for Evaporation Rate Detection

Published on: October 17, 2016

Experimental Procedure for Laboratory Studies of In Situ Burning : Flammability and Burning Efficiency of Crude Oil12:34

Experimental Procedure for Laboratory Studies of In Situ Burning : Flammability and Burning Efficiency of Crude Oil

Published on: May 1, 2018

Related Concept Videos

Distillation: Vapor–Liquid Equilibria01:01

Distillation: Vapor–Liquid Equilibria

Distillation is a separation technique that takes advantage of the boiling point properties of disparate elements in a mixture. To perform distillation, we begin by heating a miscible mixture of two liquids with a significant difference in boiling points (at least 20°C). As the solution heats up and reaches the bubble point of the more volatile component, some molecules of the more volatile component transition into the gas phase and travel upward into the condenser, which is a glass tube with...
Physical Properties of Alkanes02:33

Physical Properties of Alkanes

Alkanes are nonpolar molecules due to the presence of only carbon and hydrogen atoms. The electronegativity difference between carbon and hydrogen is minimal, and hence alkanes have a zero dipole moment. This leads to the presence of only dispersion forces between the molecules. The strength of dispersion forces is dependent on the surface area of the molecules on which they act. Since the surface area increases with the molecular length for straight-chain alkanes, the dispersion forces also...
Physical Properties of Ethers02:17

Physical Properties of Ethers

Overview
An ether molecule has a net dipole moment due to the polarity of C–O bonds. Subsequently, boiling points of ethers are lower than those of alcohols of comparable molecular weight and slightly higher than those of hydrocarbons of comparable molecular weight (Table 1).
Ethers can act as hydrogen bond acceptors, making them more water-soluble than hydrocarbons, but since ethers cannot act as hydrogen bond donors, they are much less soluble in water than alcohols. Ethers are considered...
Volatilization01:10

Volatilization

Volatilization gravimetry is an analytical technique that measures the mass lost due to the volatilization of the substance. This technique is used to estimate the amount of volatile material in a sample. To perform this method, heat a known amount of the sample to a high temperature in a crucible or other suitable vessel. The volatile substance in the sample evaporates, and the vapor is completely expelled from the crucible either by heating the sample or bubbling a stream of inert gas through...
Vapor Pressure02:34

Vapor Pressure

When a liquid vaporizes in a closed container, gas molecules cannot escape. As these gas phase molecules move randomly about, they will occasionally collide with the surface of the condensed phase, and in some cases, these collisions will result in the molecules re-entering the condensed phase. The change from the gas phase to the liquid is called condensation. When the rate of condensation becomes equal to the rate of vaporization, neither the amount of the liquid nor the amount of the vapor...
Acid-Catalyzed Dehydration of Alcohols to Alkenes02:35

Acid-Catalyzed Dehydration of Alcohols to Alkenes

In a dehydration reaction, a hydroxyl group in an alcohol is eliminated along with the hydrogen from an adjacent carbon. Here, the products are an alkene and a molecule of water. Dehydration of alcohols is generally achieved by heating in the presence of an acid catalyst. While the dehydration of primary alcohols requires high temperatures and acid concentrations, secondary and tertiary alcohols can lose a water molecule under relatively mild conditions.