Related Experiment Video
Updated: Jan 25, 2026

Author Spotlight: Process Development for the Spray-Drying of Probiotic Bacteria and Evaluation of the Product Quality
Published on: April 7, 2023
Effect of process parameters on the production and drying of Leuconostoc mesenteroides cultures
1Food Research and Development Centre (FRDC), Agriculture and Agrifood Canada, 3600, Boulevard Casavant West, Saint-Hyacinthe, Quebec, Canada J2S 8E3.
Abstract:
Leuconostoc mesenteroides BLAC was grown on MRS broth or on a carrot juice medium, and the effects of sugar concentration, type of pH control, aeration and fermentor size on viable counts were examined. The effect on viability of the type of centrifuge used to concentrate the bacterial culture was also examined. When the MRS broth had the traditional 110 mM glucose, pH control did not increase the final population. However, using a zone pH control mode, increasing the glucose content of MRS both from 110 to 220 mM almost doubled the population. In MRS broth, the amount of acetic acid produced was the same for all treatments, and was proportional to the amount of citrate consumed. There was a significantly lower cell yield in the carrot juice medium when the pH was not regulated. In the carrot juice medium, pH had a more pronounced effect on the final population level than did aeration, even though the quantity of viable cells was greater when the culture was aerated. In MRS broth, glucose was completely consumed during fermentation, but this was not the case in carrot juice medium. Aeration resulted in increased acetic acid content of the fermented medium. Viable counts were not affected by scaling the volume of the fermentation from 2 to 15 l,or by the type of centrifuge used to concentrate the cells. Cells were concentrated by a factor of 10, but in both centrifuge types, viable counts showed only an eightfold average increase. However, freeze-dried powders obtained from the continuous pilot-plant-centrifuged cultures had, on the average, 33% lower populations than those obtained from the laboratory unit.
More Related Videos
05:55High-throughput, Microscale Protocol for the Analysis of Processing Parameters and Nutritional Qualities in Maize Zea mays L.
Published on: June 16, 2018
07:06Wicking Tests for Unidirectional Fabrics: Measurements of Capillary Parameters to Evaluate Capillary Pressure in Liquid Composite Molding Processes
Published on: January 27, 2017
Related Concept Videos
Dry Friction
To illustrate this concept, imagine a wooden crate resting on a rough, non-uniform horizontal surface. When an external force is applied to...
Wave Parameters
Drying Shrinkage
A portion of this drying shrinkage can be reversed; if the concrete is...
Characteristics of Dry Friction
Before the wheelbarrow starts moving, the static frictional force acts tangentially to the contact surface, opposing the force that is about to induce the motion. This frictional force prevents the...
Distributions to Estimate Population Parameter
Washing, Drying, and Ignition of Precipitates