Technical note: Sampling methodology for relating sarcomere length, collagen concentration, and the extent of...

The objective of this study was to determine the effect of sampling methodology on the relationship between longissimus tenderness and measures of biochemical meat traits. Sampling methodology included measurements of sarcomere length, collagen concentration, and postmortem desmin proteolysis on raw samples and measurements of these same traits on the same cooked meat used for shear force measurement. Twenty crossbred steers and 20 crossbred barrows were used for these studies. The beef longissimus thoracis were vacuum-packaged, stored at 2 degrees C until 14 d postmortem, then frozen and stored at -30 degrees C. The pork longissimus thoracis et lumborum were vacuum-packaged, stored at 2 degrees C until 7 d postmortem, then frozen and stored at -30 degrees C. Trained sensory panel tenderness rating ranged from 3.1 to 7.6 for beef and 4.1 to 7.4 for pork. The coefficient of variation was lower for sarcomere length than for all other traits. Simple correlation coefficients between measurements on raw and cooked samples were 0.58 (beef) and 0.11 (pork) for sarcomere length, 0.66 (beef) and 0.59 (pork) for collagen, and 0.74 (beef) and 0.76 (pork) for desmin degradation. Simple correlation coefficients between biochemical traits and measures of tenderness (Warner-Bratzler shear force and trained sensory tenderness rating) were higher or not different for cooked compared to raw samples. Correlation coefficients between biochemical traits and tenderness rating were 0.38 (raw) and 0.22 (cooked) for sarcomere length, -0.12 (raw) and -0.45 (cooked) for collagen, and 0.48 (raw) and 0.80 (cooked) for desmin degradation in beef longissimus and 0.14 (raw) and 0.15 (cooked) for sarcomere length, -0.38 (raw) and -0.33 (cooked) for collagen, and 0.53 (raw) and 0.67 (cooked) for desmin degradation in pork longissimus. The coefficients of determination for explaining variation in tenderness rating using sarcomere length, collagen concentration, and desmin degradation for raw and cooked samples were 0.43 and 0.73 (beef) and 0.48 and 0.57 (pork), respectively. This study indicates that measurements of biochemical traits on the same cooked meat as used for shear force determination account for more of the variation in measures of tenderness than biochemical measurements made on a separate raw sample.