Effect of diode laser irradiation on root surfaces in vitro

The objective of this study was to evaluate possible morphological alterations of root surfaces after GaAlAs-diode laser (809 nm) irradiation under standardized in vitro conditions.

Root specimens obtained from extracted periodontally diseased teeth were scaled and root planed with curettes followed by air-powder abrasive treatment prior to lasing. The variable parameters were power output (0.5-2.5 W) and exposure time (10-30 sec per specimen). Additionally, the effect of a saline solution and a human blood film on the root surface was investigated. The root segments were analyzed by means of a reflected light microscope. Photographs before and after irradiation were taken and evaluated. The scale of carbonization was quantified using a grid laid over the photographs. Specimens with distinct morphological changes were analyzed with a scanning electron microscope.

Lasing dry specimens and specimens moistened with saline resulted in no detectable alterations, irrespective of irradiation time and power output applied. Depending on different settings, irradiation caused severe damages to the root surface when segments were covered by a thin blood film. Irradiation at a power output of 1 Watt and below had barely any negative effect on the root surface, whereas lasing at 1.5, 2.0, and 2.5 Watt resulted in partial or total carbonizations of the root samples. The angle of irradiation had a significant effect on the scale of the root surface damage (Mann-Whitney U test,p < 0.05).

The diode laser may cause damage to periodontal hard tissues if irradiation parameters are not adequate.