Fate of excited probes in micellar systems

This article presents studies on the photophysical and photochemical behavior of probes within micellar systems: organized emulsifier/polymer aggregates; the intra- and interpolymer association of amphiphilic polymers; monomer-swollen micelles (microdroplets); and the interfacial layer. Pyrene (Py) as a probe is particularly attractive because of its ability to measure the polarity of its microenvironment. Dipyme yields information on the microviscosity of micellar systems. Probes such as laurdan and prodan can be used to explore the surface characteristics of micelles or microdroplets. The dansyl group has a special photophysical property that gives information about the local polarity and mobility (viscosity) of the microenvironment. The organized association of amphiphilic polymer and emulsifier introduces a heterogeneity in the local concentration of the reactants. This heterogeneity also results from the attractive interaction between hydrophilic monomer and emulsifier in the case when the monomer carries a positive charge and the counterpart a negative one, and vice versa. Some emulsifiers can bind to the amphiphilic copolymers by simple partitioning between the aqueous phase and the polymer--non-cooperative association. The interaction between micelles (microdroplets) and charged polymers leads to the formation of mixed micelles. Binding emulsifiers to these polymers was detected at emulsifier concentrations much below the critical micellar concentration (CMC). Emulsifiers often interact cooperatively with polymers at the critical aggregation concentration (CAC) below the CMC, forming micelle-like aggregates within the polymer. The CAC can be taken as a measure of interaction between the emulsifier and polymer. A decrease in the monomer fluorescence intensity of probe-labeled polymer results from increased excimer formation, or higher aggregates within the unimolecular polymeric micelles. An increase in the monomer fluorescence intensity of probe-labeled polymer within the micellar system can be ascribed to shielding of the probe chromophores by emulsifier micelles. The quenching of probe emission by (un)charged hydrophilic monomer depends on partitioning of the monomer between the aqueous phase and the micelles. Penetration of reactants into the interfacial layer determines the quenching of the hydrophobic probe by hydrophilic quencher, or vice versa. Quenching depends on the thickness, density and charge of the interfacial layer. Compartmentalization prevents the carbonyl compound and unsaturated monomer from coming into sufficiently close contact to allow singlet or triplet-monomer interaction. All negatively charged carbonyl probe molecules are quenched with significantly lower rates than the parent neutral hydrophobic benzophenone molecules, which were located further inside the aggregates. This results from the different conformation and allocation of reactants within the micellar system. In the reverse micelles, quenching depends on the amount of water in the interfacial layer and the total area of the water/oil interface.