Related Experiment Video
Updated: Aug 5, 2026

Utilizing Electroencephalography Measurements for Comparison of Task-Specific Neural Efficiencies: Spatial Intelligence Tasks
Published on: August 9, 2016
Effect of signal length on the performance of independent component analysis when extracting the lambda wave
L Vigon1, R Saatchi, J E W Mayhew
1School of Engineering, Sheffield Hallam University, UK.
Abstract:
The aim of the study was to investigate the effect of signal length on the performance of a signal source separation method, independent component analysis (ICA), when extracting the visual evoked potential (EP) lambda wave from saccade-related electro-encephalogram (EEG) waveforms. A method was devised that enabled the effective length of the recorded EEG traces to be increased prior to processing by ICA. This involved abutting EEG traces from an appropriate number of successive trials (a trial was a set of waveforms recorded from 64 electrode locations in a study investigating saccade performance). ICA was applied to the saccade-related EEG and electro-oculogram (EOG) waveforms recorded from the electrode locations. One spatial and five temporal features of the lambda wave were monitored to assess the performance of ICA applied to both abutted and non-abutted waveforms. ICA applied to abutted trials managed to extract all six features across all seven subjects included in the study. This was not the case when ICA was applied to the non-abutted trials. It was quantitatively demonstrated that the process of abutting EEG waveforms was useful for ICA preprocessing when extracting lambda waves.
More Related Videos
08:25Combined Invasive Subcortical and Non-invasive Surface Neurophysiological Recordings for the Assessment of Cognitive and Emotional Functions in Humans
Published on: May 19, 2016
08:42Measurement of the Directional Information Flow in fNIRS-Hyperscanning Data using the Partial Wavelet Transform Coherence Method
Published on: September 3, 2021
Related Concept Videos
Inductively Coupled Plasma Atomic Emission Spectroscopy: Instrumentation
There are three main types of inductively coupled plasma atomic emission spectroscopy (ICP-AES) instruments: sequential, simultaneous multichannel, and Fourier transform instruments, with the latter being less commonly used.
Even and Odd Signals
Linear time-invariant Systems
The input-output behavior of an LTI system can be fully defined by its response to an impulsive excitation at its input. Once this impulse response is known, the system's reaction to any other input can be calculated...
Basic signals of Fourier Transform
The sinc function, defined as sinc(x) = sin(πx)/(πx), is particularly notable for its symmetry and behavior at zero. It...
Aliasing
If the sampling frequency is below the Nyquist rate, these replicas overlap, preventing the original signal...
Traveling Waves: Lossless Lines