Related Experiment Video
Updated: Oct 1, 2026

Profiling Volatile Compounds in Blackcurrant Fruit using Headspace Solid-Phase Microextraction Coupled to Gas Chromatography-Mass Spectrometry
Published on: June 9, 2021
Evaluation of volatile compounds in different types of ghee using direct injection with gas chromatography-mass
Uday R Wadodkar1, Jagjit S Punjrath, Amrish C Shah
1National Dairy Development Board, Gujarat, India. nddb_bajajidairy@vsnl.com
Abstract:
Desi ghee (DG) was prepared from fermented cream followed by heat clarification (desi method) in the laboratory and butter oil (BO) was prepared from fresh butter by melting and centrifugation. Fresh samples of three brands of industrial ghee (IG-1, IG-2, IG-3) were collected from the local market. Volatile compounds of desi and industrial ghee and butter oil were isolated and concentrated using direct injection and cryofocussing techniques; separation and identification was by Gas Chromatography Mass Spectrometry (GCMS). A maximum of 36 compounds were detected in desi ghee whereas compounds detected in three industrial ghee samples varied from 22-29. The lowest number of compounds (16) was detected in butter oil. Of the identified compounds, maltol, 5-hydroxymethyl furfuraldehyde, dihydrodihydroxypyranone, 1,3-butanediol and 1-octanol were identified only in desi ghee volatiles. The concentration of acetic acid was found to be remarkably higher in desi ghee volatiles than in industrial ghee. Also the levels of identified fatty acids, methyl ketones, aldehydes, lactones and alcohols were high in desi ghee volatiles compared with industrial ghee and butter oil. In total, 62 compounds were detected, which included 6 aldehydes, 12 ketones, 8 each of fatty acids, alcohols and lactones, 4 each of esters and hydrocarbons or other compounds, and 12 compounds remained unidentified.
More Related Videos
05:31Gas Chromatography-Mass Spectrometry Paired with Total Vaporization Solid-Phase Microextraction as a Forensic Tool
Published on: May 25, 2021
11:44Qualitative Characterization of the Aqueous Fraction from Hydrothermal Liquefaction of Algae Using 2D Gas Chromatography with Time-of-flight Mass Spectrometry
Published on: March 6, 2016
Related Concept Videos
Gas Chromatography: Introduction
In GC, a sample is vaporized and mixed with an inert carrier gas (the mobile phase), which transports it through a column.
Gas Chromatography–Mass Spectrometry (GC–MS)
A gas chromatograph consists of a long, narrow capillary column with a polysiloxane coating on the inner wall. The coating...
Gas Chromatography: Sample Injection Systems
Two primary injection methods are used...
Gas Chromatography: Overview of Detectors
A non-destructive detector allows a sample to be analyzed without altering or consuming it, meaning the sample can be collected after detection for further analysis. Examples include thermal conductivity detectors and...
Gas Chromatography: Types of Detectors-II
Gas Chromatography: Types of Detectors-I
TCD is the earliest and most widely used detector that operates by measuring the changes in the thermal conductivity of the carrier gas. When a sample compound enters the detector,...