Related Experiment Video

Updated: Aug 3, 2026

Protocol for Relative Hydrodynamic Assessment of Tri-leaflet Polymer Valves
11:12

Protocol for Relative Hydrodynamic Assessment of Tri-leaflet Polymer Valves

Published on: October 17, 2013

Valsalva leak point pressure: steps toward standardization

F Daneshgari1

  • 1University of Colorado Health Sciences Center, 4200 East 9th Avenue, Box C-319, Denver, CO 80262, USA. Firouz.daneshgari@uchsc.edu

Current Urology Reports
|June 27, 2002
PubMed

More Related Videos

Design and Use of a Full Flow Sampling System (FFS) for the Quantification of Methane Emissions08:18

Design and Use of a Full Flow Sampling System (FFS) for the Quantification of Methane Emissions

Published on: June 12, 2016

An Ex Vivo Porcine Model for Hydrodynamic Testing of Experimental Aortic Valve Procedures and Novel Medical Devices06:56

An Ex Vivo Porcine Model for Hydrodynamic Testing of Experimental Aortic Valve Procedures and Novel Medical Devices

Published on: August 25, 2023

Related Concept Videos

Pascal's Law01:04

Pascal's Law

In 1653, the French philosopher and scientist Blaise Pascal published "Treatise on the Equilibrium of Liquids," which discussed the principles of static fluids. A static fluid is a fluid that is not in motion. When a fluid is not flowing, we say that the fluid is in static equilibrium. If the fluid is water, we say it is in hydrostatic equilibrium. For a fluid in static equilibrium, the net force on any part of the fluid must be zero; otherwise, the fluid will start to flow. Pascal observed...
Fluid Pressure01:14

Fluid Pressure

In mechanical engineering, fluid pressure plays a critical role in designing systems that utilize liquid flow, such as hydraulic systems, pumps, and valves. When designing these systems, engineers must ensure they can withstand the forces created by fluid pressure to avoid damage or failure.
According to Pascal's law, a fluid at rest will generate equal pressure in all directions. This pressure is measured as a force per unit area, and its magnitude depends on the fluid's specific weight or...
Concept of Pressure at a Point01:15

Concept of Pressure at a Point

The concept of pressure at a point in a fluid establishes that pressure within a fluid is uniform in all directions at a specific location. This uniformity occurs because fluid molecules exert force evenly across any point due to their random motion and continuous collisions within the fluid. Pressure at a point is determined by the surrounding fluid molecules and is influenced by factors like depth and density, rather than by shape or orientation.
In a fluid at rest, pressure acts equally in...
Bernoulli's Equation: Problem Solving01:16

Bernoulli's Equation: Problem Solving

A Venturi meter is essential for measuring fluid flow rates in pipelines. It utilizes the relationship between fluid velocity and pressure described by Bernoulli's equation. When installed in a sewage system, the Venturi meter accurately determines the wastewater flow rate by measuring pressure differences.
The first step is to compute the cross-sectional areas of the pipe and the Venturi throat to analyze the pressure difference indicated by the pressure gauge. Next, the continuity equation is...
Static, Stagnation, Dynamic and Total Pressure01:24

Static, Stagnation, Dynamic and Total Pressure

The concept of static, stagnation, dynamic, and total pressure is fundamental in fluid dynamics, often explained using Bernoulli's equation:
Single Pipe Systems01:24

Single Pipe Systems

In pipe flow analysis, problems are typically categorized into three types — Type I, Type II, and Type III — based on the known parameters and the desired outcome. Each type of problem addresses specific engineering requirements using fluid properties, pipe characteristics, and operational conditions.
In a Type I problem, fluid properties (density and viscosity), pipe characteristics (including diameter, length, and surface roughness), and the flow rate or average velocity are known. The...