Related Experiment Videos
The effect of optical design on micromanipulator spot size using CO2 laser irradiation
Kenneth K H Chao1, Eric Cheung, William B Armstrong
1School of Medicine, University of Texas Health Science Center at San Antonio, USA.
Objective:
The study goal was to compare the laser spot size created using reflective and refractive micromanipulators with a CO(2) laser and to determine the sensitivity of spot size to laser power.
Study Design And Setting:
A CO(2) laser and operating microscope (400-mm focal length) was coupled to either a reflective (Cassegrain-like) or refractive micromanipulator. Laser spot size was determined by measuring the region of ablation created by laser irradiation of wood (dry tongue depressors), exposed photographic film, and agar gel using optical micrometry. Laser power varied from 0.5 to 20 W with pulse durations of 0.1 and 0.5 second.
Results:
The reflective micromanipulator demonstrated overall smaller spot sizes for a given laser power and lower incremental change in spot size with increasing power. The reflective design demonstrated less sensitivity to increases in laser power.
Conclusions:
Micromanipulator optical design can result in significant differences in laser spot size. The reflective device used in this study demonstrated less sensitivity to increasing laser power.