Nutrient removal and sludge production in the coagulation-flocculation process
Related Experiment Videos
M I Aguilar1, J Sáez, M Lloréns
1Department of Chemical Engineering, University of Murcia, Spain.
Abstract:
Nutrient removal and sludge production in the coagulation-flocculation process, applied to a slaughterhouse effluent, have been studied. Fe2(SO4)3, Al2(SO4)3 and polyaluminium chloride were used as coagulants. Inorganic products were used as coagulant aids: activated silica, powdered activated carbon and precipitated calcium carbonate and synthetic polyelectrolytes: cationic polyacrylamide, polyacrilic acid, anionic polyacrylamide and polyvinyl alcohol. Performances were measured under optimum conditions for the products used. They were found after studying the different variables which influence the process. Phosphorus removal is very high (approximately 100% for the orthophosphate and between 98.93% and 99.90% for the total phosphorus). Ammonia nitrogen removal is very low although appreciable performances are observed for albuminoid nitrogen (73.9-88.77%). The use of coagulant aids reduces the volume of the sludge produced up to 41.6%.
Related Concept Videos
Coagulation
Colloidal precipitates
Factors Affecting Solubility
Biological Treatment of Effluent and Waste Water
Precipitation and Co-precipitation
Downstream Processing