Related Experiment Video
Updated: Sep 29, 2026

Antimicrobial Peptides Produced by Selective Pressure Incorporation of Non-canonical Amino Acids
Published on: May 4, 2018
Position-dependent hydrophobicity of the antimicrobial magainin peptide affects the mode of peptide-lipid
Tomoya Tachi1, Raquel F Epand, Richard M Epand
1Graduate School of Biostudies, Kyoto University, Sakyo-ku, Kyoto 606-8501, Japan.
Abstract:
Cationic antimicrobial peptides are promising candidates as novel antibiotics of clinical usefulness. Magainin 2, a representative antimicrobial peptide isolated from the skin of the African clawed frog Xenopus leavis, electrostatically recognizes anionic lipids that are abundant in bacterial membranes, forming a peptide-lipid supramolecular complex pore, whereas the peptide does not effectively bind to zwitterionic phospholipids constituting the outer leaflets of mammalian cell membranes because of the low hydrophobicity of the peptide [Matsuzaki, K. (1999) Biochim. Biophys. Acta 1462, 1-10]. In this study, two magainin analogues with enhanced hydrophobicity, MG-H1 (GIKKFLHIIWKFIKAFVGEIMNS) and MG-H2 (IIKKFLHSIWKFGKAFVGEIMNI), with identical amino acid compositions were designed and interactions with lipid bilayers and biological activities were examined in comparison with those of MG (GIGKWLHSAKKFGKAFVGEIMNS = F5W-magainin 2). The apparent hydrophobicities and hydrophobic moments of MG-H1 and MG-H2, conventionally calculated assuming that all residues are involved in helix formation, were almost the same. MG-H2 behaved like MG except for greatly enhanced activity against zwitterionic membranes and erythrocytes. In contrast, despite a very similar calculated hydrophobicity, the observed hydrophobicity of MG-H1 was larger than that of MG-H2 because of a tendency toward helix fraying near the termini. Therefore, the physicochemical parameters of only the helical portion should be considered in characterizing peptide-lipid interactions, although this point was overlooked in most studies. Moreover, MG-H1 induced aggregation and/or fusion of negatively charged membranes. Furthermore, the peptide hydrophobicity was found to affect pore formation rate, pore size, and pore stability. These observations demonstrate that the hydrophobicity of the peptide also controls the mode of action and is dependent on the position of the hydrophobic amino acids in the peptide sequence.
More Related Videos
10:13Production and Visualization of Bacterial Spheroplasts and Protoplasts to Characterize Antimicrobial Peptide Localization
Published on: August 11, 2018
10:31A Liposome Membrane Permeability Assay for Investigating the Effects of Phosphatidylinositol Phosphate Groups on Membranotropic Action of Venom PLA2
Published on: September 26, 2025
Related Concept Videos
Antimicrobial Proteins
Interferons
Interferons (IFNs) are proteins produced by lymphocytes, macrophages, and fibroblasts infected with viruses. While IFNs cannot prevent viruses from entering and...
Inhibitors of Bacterial Protein Synthesis
Inhibitors of Gram-positive Cell Wall Synthesis
Ligand Binding Sites
Protein-ligand interactions are quite specific; even though numerous potential ligands surround a cellular protein at any given time, only a particular ligand can bind to that protein. Moreover, a ligand binds only to a dedicated area on the surface of the protein, known as the...
Clinical Significance of Antibiotic Resistance
Factors Affecting Protein-Drug Binding: Drug-Related Factors
One crucial factor in drug-protein binding is the drug's lipophilicity or its affinity for fat. More lipophilic drugs tend to have higher binding extents. For example, highly lipophilic drugs like cloxacillin exhibit substantial protein binding, with as much as 95% of the drug binding to proteins. In contrast,...