Related Experiment Video
Updated: Aug 2, 2026
On-line Analysis of Nitrogen Containing Compounds in Complex Hydrocarbon Matrixes
Published on: August 5, 2016
Failure of ProFile Ni-Ti instruments used by an inexperienced operator under access limitations
1Discipline of Endodontics, Faculty of Dentistry, University of Toronto, Ont., Canada. g.yared@utoronto.ca
Aim:
The purpose of this study was to evaluate the failure incidence of ProFile nickel-titanium rotary instruments (PRI) when used by an inexperienced operator in conjunction with different motors and under limitations of access.
Methodology:
PRI with 0.06 taper were used by an inexperienced operator in a crown-down technique. The teeth were mounted in resin arches of a phantom head to reproduce limitations of access. In groups 1-4, air, high torque control, low torque control and very low torque control motors were used, respectively. Each group included 30 canals in extracted human molars. One set of PRI sizes 40-15 was used for each canal; the PRI were sterilized before each case. A 2.5% NaOCl solution was used as an irrigant. An inexperienced operator performed all the cleaning and shaping procedures after application of a rubber dam. The opening of the mouth in the phantom head was standardized for the four groups. The number of deformed and separated instruments was recorded for the various experimental groups and analyzed statistically for significance with chi-square tests.
Results:
A high incidence of instrument deformation and separation occurred with the air, high torque control and low torque control motors. Only seven and two instruments deformed and separated, respectively, with the very low torque control motor, whereas at least 23 and 10 instruments deformed and separated respectively with the other motors.
Conclusions:
A very low torque control motor was safer than on air, high torque control or low torque control motors when PRI with 0.06 taper were used by an inexperienced operator in a crown-down manner at 170 rpm.
