Related Experiment Video
Updated: Jul 10, 2026

Atomic Scale Structural Studies of Macromolecular Assemblies by Solid-state Nuclear Magnetic Resonance Spectroscopy
Published on: September 17, 2017
Resolving the different dynamics of the fluorine sublattices in the anionic conductor BaSnF(4) by using
Santanu Chaudhuri1, Francis Wang, Clare P Grey
1Department of Chemistry, State University of New York, Stony Brook, NY 11794-3400, USA.
Abstract:
19F and (119)Sn MAS NMR spectroscopy have been used to investigate the fluoride ion conductor, BaSnF(4), a member of the MSnF(4) family of fluorite-related anionic conductors containing double layers of Sn(2+) and M(2+) cations. Two fluorine sublattices were observed by (19)F MAS NMR, which could be assigned to specific sites in the lattice. The first sublattice is due to fluorine atoms located in Ba(2+) double layers and is rigid on the MAS NMR time scale at room temperature. The second sublattice comprises the fluoride ions between the Ba(2+) and Sn(2+) layers, and the few fluorine atoms that inhabit the Sn(2+)-Sn(2+) double layers. These ions are in rapid exchange with each other, and an extremely short correlation time tau(C) for the motion of these ions of <3 x 10(-)(5) s is obtained at -100 degrees C. T(1) measurements indicate that tau(C) approaches 10(-)(8) s at room temperature. (19)F-to-(119)Sn cross-polarization (CP) experiments confirmed the assignments of the resonances, and that the fluorine atoms located next to the tin atoms are extremely mobile at room temperature (and thus do not contribute to the CP process). Two-dimensional (19)F exchange experiments showed that exchange between the rigid and mobile lattice does occur, but at a much slower rate (tau(C) approximately 10 ms at 250 degrees C). Low-temperature (19)F MAS and (19)F-to-(119)Sn CP NMR spectra demonstrate that the motion of the fluoride ions has almost completely frozen out by -150 degrees C. The results are consistent with rapid two-dimensional (anisotropic) conductivity involving the fluoride ions between the Ba and Sn layers. Conductivity in three dimensions requires hops between the ions in the BaF(2)-like layers and the mobile ions. This process does occur, but with exchange rates that are at least 6-7 orders of magnitude slower.
Related Concept Videos
¹H NMR: Complex Splitting
Splitting diagrams or splitting tree diagrams are routinely used to depict such complex couplings. While drawing splitting diagrams, the splitting with the larger coupling constant is usually applied first.
High-Resolution Mass Spectrometry (HRMS)
NMR Spectroscopy: Chemical Shift Overview
For instance, the proton...
¹³C NMR: ¹H–¹³C Decoupling
A broadband decoupling technique is used to simplify these complex, sometimes overlapping, signals. Broadband decoupling relies on a...
Mass Analyzers: Overview
Double Resonance Techniques: Overview
Spin decoupling is usually achieved by...

