Related Experiment Video

Updated: Sep 29, 2026

Experimental Procedure for Laboratory Studies of In Situ Burning : Flammability and Burning Efficiency of Crude Oil
12:34

Experimental Procedure for Laboratory Studies of In Situ Burning : Flammability and Burning Efficiency of Crude Oil

Published on: May 1, 2018

Mortality of United Kingdom oil refinery and petroleum distribution workers, 1951-1998

T Sorahan1, L Nichols, J M Harrington

  • 1Institute of Occupational Health, University of Birmingham, Edgbaston, Birmingham B15 2TT, UK. t.m.sorahan@bham.ac.uk

Occupational Medicine (Oxford, England)
|October 4, 2002
PubMed

More Related Videos

Original Experimental Approach for Assessing Transport Fuel Stability09:48

Original Experimental Approach for Assessing Transport Fuel Stability

Published on: October 21, 2016

Related Concept Videos

Microbial Bioremediation of Hydrocarbons01:26

Microbial Bioremediation of Hydrocarbons

Bioremediation is an environmentally sustainable process that employs living organisms—primarily microorganisms—to degrade or neutralize pollutants from contaminated environments. In oil spills and hydrocarbon pollution, bioremediation involves the use of hydrocarbon-degrading bacteria to transform toxic compounds into less harmful substances. This approach leverages natural microbial metabolic processes and is considered both cost-effective and ecologically favorable compared to physical or...
Combustion Energy: A Measure of Stability in Alkanes and Cycloalkanes02:14

Combustion Energy: A Measure of Stability in Alkanes and Cycloalkanes

The low reactivity in alkanes can be attributed to the non-polar nature of C–C and C–H σ bonds. Alkanes, therefore, were  initially termed as “paraffins,” derived from the Latin words: parum, meaning “too little,” and affinis, meaning “affinity.”
Alkanes undergo combustion in the presence of excess oxygen and high-temperature conditions to give carbon dioxide and water. A combustion reaction is the energy source in natural gas, liquified petroleum gas (LPG), fuel oil, gasoline, diesel fuel, and...
Standard Enthalpy of Formation02:37

Standard Enthalpy of Formation

Enthalpy changes are typically tabulated for reactions in which both the reactants and products are at the same conditions. A standard state is a commonly accepted set of conditions used as a reference point for the determination of properties under other different conditions. For chemists, the IUPAC standard state refers to materials under a pressure of 1 bar and solutions at 1 M and does not specify a temperature. Many thermochemical tables list values with a standard state of 1 atm. Because...
Toxicity Testing in Animals01:23

Toxicity Testing in Animals

Toxicity tests in animals are grounded on two main assumptions: first, the effects observed in laboratory animals can be extrapolated to humans, especially when adjusted for body surface area; second, high-dose exposure in animals is essential to identify potential human hazards from lower doses. This is based on the quantal dose-response concept, which faces the challenge of extrapolating results from relatively few test animals to much larger human populations. For example, a 0.01% incidence...
Relative Stabilities of Alkenes01:59

Relative Stabilities of Alkenes

The relative stability of alkenes can be determined by comparing their heats of hydrogenation. The lower heat of hydrogenation indicates the more stable alkene.  The three main factors determining the relative stability of alkenes are i) the number of substituents attached to the double-bond carbon atoms, ii) hyperconjugation, and iii) the stereochemistry of the double bond.
Half-life of a Reaction02:42

Half-life of a Reaction

The half-life of a reaction (t1/2) is the time required for one-half of a given amount of reactant to be consumed. In each succeeding half-life, half of the remaining concentration of the reactant is consumed. For example, during the decomposition of hydrogen peroxide, during the first half-life (from 0.00 hours to 6.00 hours), the concentration of H2O2 decreases from 1.000 M to 0.500 M. During the second half-life (from 6.00 hours to 12.00 hours), the concentration decreases from 0.500 M to...