An Investigation of the Properties of Computer-Based Case Simulations
Related Experiment Video
Updated: Sep 28, 2026

Interactive and Visualized Online Experimentation System for Engineering Education and Research
Published on: November 24, 2021
Janice Dowd Scheuneman1, Stephen G. Clyman, Yihua Van Fan
1Current address: Quality Assessment Services PO Box 5964, Trenton, New Jersey 08638, USA (Phone: 609-883-8273; Fax: 609-771-1458; E-mail: jds@aosi.com); National Board of Medical Examiners
Abstract:
Computer-based case simulations (CCS) require several development iterations, each involving a sizeable investment of time from physician volunteers and test development staff. Hence, a case that fails to demonstrate good measurement properties when administered to examinees at the pretest stage represents a costly loss. An earlier study investigated the relationship of case properties to case difficulty in part to obtain information that would permit (a) better instructions to case developers and (b) identification of problematic cases earlier in the developmental cycle. Some of the best predictors, however, were scoring points typically obtained at the pretest stage, making them inappropriate for meeting these two goals. The objective of this study was to determine if these scoring points could be predicted from cases properties that would be available early in case development. Case description variables and scoring points were available for 28 cases which were analyzed using regression procedures. Three models were identified that predicted the important scoring fairly well. These models differed primarily in the area of medicine: internal medicine, obstetrics/gynecology, or no medical area specified. The results were consistent with those found for predicting difficulty and appeared promising for better understanding of the nature of the simulations.
Related Concept Videos
Mechanistic Models: Compartment Models in Algorithms for Numerical Problem Solving
In individual population analyses, different algorithms are employed, such as Cauchy's method, which uses a...
Trial and Error and Algorithm
Machines: Problem Solving II
Biot-Savart Law: Problem-Solving
Consider a mobile phone battery bank as a source of steady current, which flows through the wire connected between the two. What is the magnitude of the magnetic field created by this current at a field point P?
To estimate the magnitude of the total magnetic field, we first consider a small current element of length dl, at a distance r from the field point. Now the following...
Typical Model Studies
Ampere-Maxwell's Law: Problem-Solving
To solve the problem, we can use the equations from the analysis of an RC circuit and Maxwell's version of Ampère's law.
For the first part of the problem,...

