Related Experiment Video
Updated: Aug 15, 2026

Three-Dimensionally Printed Microfluidic Cross-flow System for Ultrafiltration/Nanofiltration Membrane Performance Testing
Published on: February 13, 2016
Struvite formation and the fouling propensity of different materials
J D Doyle1, K Oldring, J Churchley
1School of Water Sciences, Cranfield University, SIMS, Bedfordshire, UK.
Abstract:
Struvite (MgNH4PO4 x 6H2O) fouling was investigated to identify the impact supersaturation and material had on scaling rates. Tests were undertaken at three supersaturation ratios and with three different materials: stainless steel, teflon and acrylic. Impellers consisting of a clasp unit and two corrosion coupons that could be attached were used to mix centrate liquor and precipitation was initiated by the change in pH caused by degassing. Increasing the supersaturation ratio from 1.7 to 5.3 led to a doubling in the scaling rate of stainless-steel coupons. Experiments with acrylic and teflon coupons showed the influence of surface roughness upon scaling propensity. Coarsely roughened coupons following 40 h of mixing had a mass of 413 mg of struvite attached compared to smooth coupons that had a mass of 240 mg attached. Material did have an influence upon struvite fouling but this influence diminished with increasing surface roughness.
Related Concept Videos
Factors Affecting Solubility
Qualitative Analysis
For instance, group IV...
Urinary Tract Calculi I: Introduction
Urinary Tract Calculi III: Medical Management
Microbial Bioremediation of Uranium
Acid Mine Drainage

