Mineralization of a sorbed polycyclic aromatic hydrocarbon in two soils using catalyzed hydrogen peroxide

Hydrogen peroxide (H2O2) catalyzed by soluble iron or naturally occurring soil minerals, (i.e., modified Fenton's reagent) was investigated as a basis for mineralizing sorbed and NAPL-phase benzo[a]pyrene (BaP), a hydrophobic and toxic polycyclic aromatic hydrocarbon, in two soils of different complexity. 14C-Benzo[a]pyrene was added to silica sand and a silt loam soil, and mineralization was investigated using three-level central composite rotatable experimental designs. The effects of H2O2 concentration, slurry volume, and iron(II) amendment were investigated in the silica sand systems. In a Palouse loess silt loam soil, the variables included H2O2 concentration, slurry volume, and pH, with H2O2 catalyzed by naturally occurring iron oxyhydroxides. Regression equations generated from the data were used to develop three-dimensional response surfaces describing BaP mineralization. Based on the recovery of 14C-CO2, 70% BaP mineralization was achieved in the sand within 24 h using 15 M H2O2 and an iron(II) concentration of 6.6 mM with a slurry volume of 0.3 x the field capacity of the sand. For the silt loam soil, 85% mineralization of BaP was observed using 15 M H2O2, no iron amendment, and a slurry volume of 20 x the soil field capacity. The balance of the radiolabeled carbon remained as unreacted BaP in the soil fraction. Gas-purge measurements over 5 d confirmed negligible desorption under nontreatment conditions. However, oxidation reactions were complete within 24 h and promoted up to 85% BaP mineralization, documenting that the natural rate of desorption/dissolution did not control the rate of oxidation and mineralization of the BaP. The results show that catalyzed H2O2 has the ability to rapidly mineralize sorbed/NAPL-phase BaP and that partitioning, which is often the rate-limiting factor in soil remediation, does not appear to limit the rate of vigorous Fenton-like treatment.