A phylogenetic analysis of Coelopidae (Diptera) based on morphological and DNA sequence data

The phylogenetic relationships of 22 species of Coelopidae are reconstructed based on a data matrix consisting of morphological and DNA sequence characters (16S rDNA, EF-1alpha). Optimal gap and transversion costs are determined via a sensitivity analysis and both equal weighting and a transversion cost of 2 are found to perform best based on taxonomic congruence, character incongruence, and tree support. The preferred phylogenetic hypothesis is fully resolved and well-supported by jackknife, bootstrap, and Bremer support values, but it is in conflict with the cladogram based on morphological characters alone. Most notably, the Coelopidae and the genus Coelopa are not monophyletic. However, partitioned Bremer Support and an analysis of node stability under different gap and transversion costs reveal that the critical clades rendering these taxa non-monophyletic are poorly supported. Furthermore, the monophyly of Coelopidae and Coelopa is not rejected in analyses using 16S rDNA that was manually aligned. The resolution of the tree based on this reduced data sets is, however, lower than for the tree based on the full data sets. Partitioned Bremer support values reveal that 16S rDNA characters provide the largest amount of tree support, but the support values are heavily dependent on analysis conditions. Problems with direct comparison of branch support values for trees derived using fixed alignments with those obtained under optimization alignment are discussed. Biogeographic history and available behavioral and genetic data are also discussed in light of this first cladogram for Coelopidae based on a quantitative phylogenetic analysis.