Configuration of unsheared nucleohistone. Effects of ionic strength and of histone F1 removal

Nucleohistone solubilized from rabbit thymus nuclei by an endogenous nuclease has in 0.15 M salt an exceptionally low intrinsic viscosity and very high sedimentation velocity. A fully reversible expansion of configuration occurs on lowering ionic strength. When [eta] is plotted against I-1/2 and extrapolated to high I, [eta] = 0 is reached at I = 0.4-1 M and [eta] at I = infinity is negative, contrary to the behavior of DNA and of the great majority of polyelectrolytes, which extrapolate to a positive [eta] at I = infinity. This behavior demands that the configuration of nucleohistone depends not only on electrostatic expansive forces but also on contracting forces which are not electrostatic and do not go to zero in any accessible configuration. Intramolecular hydrophobic bonds might provide such contracting forces. Increasing I above 0.15 M leads to precipitation near 0.3 M and redissolution with dissociation of F1 and expansion in 0.6 M. The expansion is largely but not completely reversed on return to 0.15 M. Much further expansion occurs in I = 1.2 M. Nucleohistone exposed to 1.2 M could not be redissolved in the original medium. Nucleohistone depleted of F1 exhibits a similar expansion as ionic strength is reduced, at higher viscosities throughout. On extrapolation to I = infinity both positive and negative viscosities were observed, on different lots, perhaps reflecting variable extraction of other histones. Circular dichroism spectra are very little affected by ionic strength (0.6 M and lower) or F1 removal, despite tenfold changes in viscosity.