Orientation of Listing's plane during static tilt in young and older human subjects

Joseph M Furman1, Robert H Schor

  • 1Department of Otolaryngology, School of Medicine, University of Pittsburgh, EEI Bldg, Ste 500, Pittsburgh, PA 15213, USA. furman@pitt.edu

Vision Research
|December 31, 2002
PubMed

Related Concept Videos

Gyroscope: Precession01:24

Gyroscope: Precession

Precession can be demonstrated effectively through a spinning top. If a spinning top is placed on a flat surface near the surface of the Earth at a vertical angle and is not spinning, it will fall over due to the force of gravity producing a torque acting on its center of mass. However, if the top is spinning on its axis, it precesses about the vertical direction, rather than topple over due to this torque. Precessional motion is a combination of a steady circular motion of the axis and the...
Anatomical Positions01:11

Anatomical Positions

In anatomy, several standard anatomical positions are used as references for describing the position and orientation of different body parts. These positions help provide a common frame of reference when discussing anatomical structures. The anatomical position is the standard reference point for describing the body's position and orientation. In this position:
The body is upright, facing forward, and standing erect.
The feet are parallel and flat on the floor.
The arms are hanging by the...
Relative Motion Analysis using Rotating Axes01:25

Relative Motion Analysis using Rotating Axes

Consider a component AB undergoing a linear motion. Along with a linear motion, point B also rotates around point A. To comprehend this complex movement, position vectors for both points A and B are established using a stationary reference frame.
However, to express the relative position of point B relative to point A, an additional frame of reference, denoted as x'y', is necessary. This additional frame not only translates but also rotates relative to the fixed frame, making it instrumental in...
Stress on an Oblique Plane01:16

Stress on an Oblique Plane

Understanding stress on an oblique plane under axial loading is pivotal in material mechanics. This analysis offers insight into a material's durability and strength, which is crucial for civil engineering and structural design. Axial loading refers to force application along the material's central axis, causing compression or elongation and leading to normal stress. Normal stress occurs when a force acts perpendicularly to the material's area, resulting in compressive or tensile stress. When...
Eccentric Axial Loading in a Plane of Symmetry01:16

Eccentric Axial Loading in a Plane of Symmetry

Eccentric axial loading occurs when an axial load is applied away from the centroidal axis of a structural member. This scenario is common in engineering, where structural elements may not be directly aligned due to various design or functional requirements.
Unsymmetric Bending - Angle of Neutral Axis01:15

Unsymmetric Bending - Angle of Neutral Axis

Unsymmetrical bending occurs when a structural member is subjected to bending moments in a plane that does not align with the member's principal axes. This scenario typically arises in beams and other structural components when loads are applied at non-ideal angles, introducing complexities in stress analysis.
When a bending moment is applied at an angle θ concerning the vertical axis of a symmetrical member, it can be resolved into components along the member's principal centroidal axes. The...