Effect of rinsing hydrocolloid impressions using acidic electrolyzed water on surface roughness and surface hardness...

The present study investigated the effect on the surface quality of resultant stone models of rinsing hydrocolloid impressions using acidic electrolyzed water. Two brands of alginate impression materials (Aroma Fine DFIII, Jeltrate Plus), an agar impression material (Ajisai) designed for agar/alginate combined impression, and dental stone (New Plastone) were used to make the test specimens. For the rinsing of impressions, acidic electrolyzed water having a pH value of 2.3, an oxidation-reduction potential of 1,230 mV, and a residual chlorine concentration of 45.0 ppm, was prepared. Alginate, agar and agar/alginate combined impressions were rinsed using acidic electrolyzed water or tap water for 30 sec and 3 min, and as a control, these impressions were not rinsed with any water. Disk-shaped stone specimens obtained from rinsed impressions were evaluated with respect to surface roughness (Ra) and surface hardness (scratch depth), and scanning electron microscope (SEM) observations were performed. The stone specimens obtained from rinsed impressions using acidic electrolyzed water showed a surface quality equivalent to that of the stone specimens obtained from the rinsed impression using tap water. This result suggests that the use of acidic electrolyzed water for rinsing is an acceptable treatment for hydrocolloid impressions, so long as the rinsing time is from 30 sec to 3 min.