Kinetic studies of iron deposition in horse spleen ferritin using O2 as oxidant

An optical flow cell provided a means to conveniently measure the rate of successive Fe(2+) oxidation reactions catalyzed by horse spleen ferritin (HoSF) to determine if both ferroxidase and mineral core Fe(2+) oxidation reactions occur. The oxygen concentration and pH were held constant and multiple additions of Fe(2+)/HoSF ratios of 1, 10, 100, 150, 250 and 400 were conducted, creating core sizes ranging from 12 to 2800. During these oxidations, the absence of nonspecific Fe(OH)(3) formation and the presence (>95%) of Fe(OH)(3) deposited within the core of HoSF demonstrated the validity of monitoring iron deposition into HoSF by this procedure. Initial rates for oxidation of 5-50 Fe(2+)/HoSF established that the reaction is overall first order in Fe(2+) concentration. However, when full progress curves were analyzed at a variety of Fe(2+)/HoSF ratios, two first-order reactions (k(1) approximately 0.035 s(-1) and k(2) approximately 0.007 s(-1)) were found to contribute to the overall Fe(2+) oxidation reaction. The proportion of the fast reaction increased with increasing Fe(2+)/HoSF ratio until at approximately 400, it was the dominant reaction. For the Fe(2+)/HoSF ratios examined, the overall rate of iron deposition is independent of the size of the mineral core, a result suggesting that an increasing mineral core size does not enhance the rate of Fe(2+) oxidation. Comparison of successive additions of 1.0 Fe(2+)/HoSF showed that oxidation of the first 8-10 Fe(2+) produced a Fe(III) species with a lower molar absorptivity per Fe(III) than that of the bulk core. Measurement of the H(+)/Fe(2+) ratio confirmed this difference in behavior by giving an H(+)/Fe(2+) ratio of approximately 1.0 below and 2.0 for ratios >30 Fe(2+)/HoSF. The faster reaction was attributed to ferroxidase catalysis and the slow reaction to nonspecific ferroxidase activity of the HoSF protein shell.