Related Experiment Video

Updated: Jul 19, 2026

Reactive Inkjet Printing and Propulsion Analysis of Silk-based Self-propelled Micro-stirrers
09:23

Reactive Inkjet Printing and Propulsion Analysis of Silk-based Self-propelled Micro-stirrers

Published on: April 26, 2019

Theoretical elucidation of kinetic and thermodynamic control of radical addition regioselectivity

Andrew G Leach1, Renxiao Wang, G Erich Wohlhieter

  • 1Department of Chemistry and Biochemistry, University of California, Los Angeles, California 90095-1569, USA.

Journal of the American Chemical Society
|April 3, 2003
PubMed

More Related Videos

Optimization of An Air-Based Heat Management System for Dusty Particulate Matter-Covered Lithium-Ion Battery Packs10:36

Optimization of An Air-Based Heat Management System for Dusty Particulate Matter-Covered Lithium-Ion Battery Packs

Published on: November 3, 2023

Spatiotemporal Control of Protein Activity through Optogenetic Allosteric Regulation08:00

Spatiotemporal Control of Protein Activity through Optogenetic Allosteric Regulation

Published on: October 4, 2024

Related Concept Videos

Allosteric Regulation01:08

Allosteric Regulation

Allosteric regulation of enzymes occurs when the binding of an effector molecule to a site that is different from the active site causes a change in the enzymatic activity. This alternate site is called an allosteric site, and an enzyme can contain more than one of these sites. Allosteric regulation can either be positive or negative, resulting in an increase or decrease in enzyme activity. Most enzymes that display allosteric regulation are metabolic enzymes involved in the degradation or...
Le Chatelier's Principle: Changing Temperature02:19

Le Chatelier's Principle: Changing Temperature

Consistent with the law of mass action, an equilibrium stressed by a change in concentration will shift to re-establish equilibrium without any change in the value of the equilibrium constant, K. When an equilibrium shifts in response to a temperature change, however, it is re-established with a different relative composition that exhibits a different value for the equilibrium constant.
To understand this phenomenon, consider the elementary reaction:
Introduction to Mechanisms of Enzyme Catalysis01:13

Introduction to Mechanisms of Enzyme Catalysis

For many years, scientists thought that enzyme-substrate binding took place in a simple "lock-and-key" fashion. This model stated that the enzyme and substrate fit together perfectly in one instantaneous step. However, current research supports a more refined view scientists call induced fit. The induced-fit model expands upon the lock-and-key model by describing a more dynamic interaction between enzyme and substrate. As the enzyme and substrate come together, their interaction causes a mild...
Electrophilic Addition of HX to 1,3-Butadiene: Thermodynamic vs Kinetic Control01:23

Electrophilic Addition of HX to 1,3-Butadiene: Thermodynamic vs Kinetic Control

The addition of a hydrogen halide to 1,3-butadiene gives a mixture of 1,2- and 1,4-adducts. Since more substituted alkenes are more stable, the 1,4-adduct is expected to be the major product. However, the product distribution is strongly influenced by temperature; low temperature favors the 1,2-adduct, whereas the 1,4-adduct is predominant at high temperature.
The Two-State Receptor Model01:29

The Two-State Receptor Model

The two-state receptor model explains a drug's interaction with receptors, such as G protein-coupled receptors and ligand-gated ion channels, to induce or inhibit a biological response. When no natural ligands are present, a receptor exists in an equilibrium of inactive (Ri) and active (Ra) conformations. The inactive form does not produce a response, while the active form generates a basal effect known as constitutive activity.
The binding affinity of a drug determines its interaction with one...
Bioreactor Controls-II01:18

Bioreactor Controls-II

In aerobic fermentations, oxygen is vital for microbial growth and metabolite production. Since air comprises only about 20% oxygen and the gas is poorly soluble in water—just 9 ppm at 20°C—supplying sufficient oxygen becomes a critical challenge, especially in high-demand processes like yeast growth or citric acid production. Even a fully saturated broth may offer only a few seconds of oxygen availability.To address this, sterile or scrubbed air is introduced into the fermentor via a sparger...