Comparison of waterless hand antisepsis agents at short application times: raising the flag of concern
Related Experiment Video
Updated: Sep 26, 2026

A Method to Test the Efficacy of Handwashing for the Removal of Emerging Infectious Pathogens
Published on: June 7, 2017
Sasi Dharan1, Stéphane Hugonnet, Hugo Sax
1Infection Control Program, Department of Internal Medicine, University of Geneva Hospitals, Geneva, Switzerland.
Objective:
Although alcohol-based hand rinses and gels have recommended application times of 30 to 60 seconds, healthcare workers usually take much less time for hand hygiene. We compared the efficacies of four alcohol-based hand rubs produced in Europe (hand rinses A, B, and C and one gel formulation) with the efficacy of the European Norm 1500 (EN 1500) reference waterless hand antisepsis agent (60% 2-propanol) at short application times.
Design:
Comparative crossover study.
Setting:
Infection Control Program laboratory of a large tertiary-care teaching hospital.
Participants:
Twelve healthy volunteers.
Intervention:
Measurement of residual bacterial counts and log reduction factors following inoculation of fingertips with Staphylococcus aurens American Type Culture Collection (ATCC) 6538, Pseudomonas aeruginosa ATCC 15442, and a clinical isolate of Enterococcus faecalis.
Results:
All hand rinses satisfied EN 1500 standards following a single application for 15 and 30 seconds, but reduction factors for the gel formulation were significantly lower for all tested organisms (all P < .025).
Conclusions:
Under stringent conditions similar to clinical practice, all three hand rinses proved to be more efficacious than the marketed alcohol-based gel in reducing bacterial counts on hands. Further studies are necessary to determine the in vivo efficacy of alcohol-based gels and whether they are as efficacious as alcohol-based rinses in reducing the transmission of nosocomial infections.
More Related Videos
Related Concept Videos
Hand hygiene
Hand washing...
Handwashing II: Pre-procedure and Initial Procedure Steps
The hand washing procedure itself includes the following steps. First, cover cuts, if any, on hands with a waterproof dressing. Cuts and abrasions can become contaminated with bacteria hindering the ability to clean the area thoroughly. In addition, repeated hand washing can worsen an injury. The nails must be short and clean, without nail paint...
Handwashing I: Introduction and Types of Equipment
Hand wash basins in clinical areas should have faucets that can be turned on and off without using the hands; that is, they should be non-touch or lever-operated.
Handwashing III: During the Procedure and Post-Procedure Steps
Antimicrobial Effectiveness
Chemical Agents for Microbial Control

