Ostwald solubility coefficients of some industrially important substances
British Journal of Industrial Medicine
|May 1, 1976
Abstract:
Solubility coefficients in blood for benzene, toluene, and xylene were determined as 6.5, 16, and 42 respectively. In lard and olive oil, which were taken to represent human fat, corresponding values were about 450, 1300, and 3900. The coefficient for vinyl chloride in lard and olive oil was 20; the value in blood was too low to be determined by the technique used. Trichloroethylene, used as a marker, was found to have a coefficient in lard of 660, and in olive oil of 710, rather lower values than have been accepted for fat.
Related Concept Videos
Solubility of Ionic Compounds
Solubility is the measure of the maximum amount of solute that can be dissolved in a given quantity of solvent at a given temperature and pressure. Solubility is usually measured in molarity (M) or moles per liter (mol/L). A compound is termed soluble if it dissolves in water.
Physical Properties Affecting Solubility
Solutions of Gases in Liquids
As for any solution, the solubility of a gas in a liquid is affected by the attractive intermolecular forces between solute and solvent species. Unlike solid and liquid solutes, however, there is no solute-solute intermolecular attraction to overcome when a gaseous solute dissolves in a liquid solvent since the atoms or molecules comprising a gas are far separated and experience negligible interactions. Consequently, solute-solvent interactions are the sole...
As for any solution, the solubility of a gas in a liquid is affected by the attractive intermolecular forces between solute and solvent species. Unlike solid and liquid solutes, however, there is no solute-solute intermolecular attraction to overcome when a gaseous solute dissolves in a liquid solvent since the atoms or molecules comprising a gas are far separated and experience negligible interactions. Consequently, solute-solvent interactions are the sole...
Solubility Equilibria
Solubility equilibria are established when the dissolution and precipitation of a solute species occur at equal rates. These equilibria underlie many natural and technological processes, ranging from tooth decay to water purification. An understanding of the factors affecting compound solubility is, therefore, essential to the effective management of these processes. This section applies previously introduced equilibrium concepts and tools to systems involving dissolution and precipitation.
The...
The...
Solubility Equilibria: Ionic Product of Water
Pure water is a weak electrolyte; only a small amount ionizes into hydrogen and hydroxide ions. At any given temperature, the concentration of undissociated water is almost constant, so the ionic product of water is the product of the hydrogen and hydroxide ion concentrations, denoted as Kw. The square root of Kw gives the individual ion concentrations.
The ionic product of water varies with temperature, and its value is 1.0 x 10−14 at standard experimental conditions. Per Le Chatelier's...
The ionic product of water varies with temperature, and its value is 1.0 x 10−14 at standard experimental conditions. Per Le Chatelier's...
Gas Solubility
Gas solubility in liquids forms liquid-gas solutions, such as soft drinks, where carbon dioxide is dissolved in water, and the ocean, where the solubility of oxygen and carbon dioxide supports marine life. The ability of oceans to dissolve gases impacts weather conditions in the troposphere.However, gas-liquid interactions vary. For instance, hydrogen chloride gas is highly soluble in water, while oxygen's solubility is much lower. Because these solutions are non-ideal, Raoult’s law, which...
Ostwald’s Dilution Law
Consider a binary electrolyte AB with a concentration ‘c’ that reversibly dissociates into its constituent ions. The degree of this dissociation is represented by ⍺. This means that the equilibrium concentration of each ionic species can be expressed as ⍺c. As well as this, the fraction of the electrolyte that remains undissociated at equilibrium is given by (1−⍺). The corresponding equilibrium concentration for this undissociated portion is then calculated as (1−⍺)c. For such solutions,...


