Slow passage through a transcritical bifurcation for Hamiltonian systems and the change in action due to a

Richard Haberman1

  • 1Department of Mathematics, Southern Methodist University, Dallas, Texas 75275.

Related Concept Videos

Transmission-Line Differential Equations01:26

Transmission-Line Differential Equations

Transmission lines are essential components of electrical power systems. They are characterized by the distributed nature of resistance (R), inductance (L), and capacitance (C) per unit length. To analyze these lines, differential equations are employed to model the variations in voltage and current along the line.
Line Section Model
A circuit representing a line section of length Δx helps in understanding the transmission line parameters. The voltage V(x) and current i(x) are measured from the...
Euler Equations of Motion01:19

Euler Equations of Motion

Imagine a rigid body that is rotating at an angular velocity of ω within an inertial frame of reference. Along with this, picture a second rotating frame that is attached to the body itself. This frame moves along with the body and possesses an angular velocity of Ω. The total moment about the center of mass is calculated by adding the rate of change of angular momentum about the center of mass in relation to the rotating frame and the cross-product of the body's angular velocity and its...
Hyperbolas01:30

Hyperbolas

A hyperbola is a conic section produced when a double-napped cone is intersected by a plane at an angle steeper than the slope of the cone, such that it cuts through both nappes. This intersection yields two separate, mirror-image curves known as branches, which open away from each other along the transverse axis. The nearest points on each branch to the hyperbola’s center are termed vertices, and the distance from the center to a vertex is denoted by a. Perpendicular to the transverse axis is...
Euler's Equations of Motion01:28

Euler's Equations of Motion

In fluid mechanics, shear stresses arise from viscosity, which represents a fluid's internal resistance to deformation. For low-viscosity fluids, like water, these stresses are minimal, simplifying flow analysis by allowing the fluid to be treated as inviscid, or frictionless. In an inviscid fluid, shear stresses are absent, leaving only normal stresses, which act perpendicularly to fluid elements. Notably, pressure — defined as the negative of the normal stress — remains uniform across...
Second Order systems II01:18

Second Order systems II

In an underdamped second-order system, where the damping ratio ζ is between 0 and 1, a unit-step input results in a transfer function that, when transformed using the inverse Laplace method, reveals the output response. The output exhibits a damped sinusoidal oscillation, and the difference between the input and output is termed the error signal. This error signal also demonstrates damped oscillatory behavior. Eventually, as the system reaches a steady state, the error diminishes to zero.
If  ζ...
Eulerian and Lagrangian Flow Descriptions01:22

Eulerian and Lagrangian Flow Descriptions

Fluid flow analysis is critical in many scientific and engineering disciplines, and two principal approaches are used to describe this flow: the Eulerian and Lagrangian methods. These methods offer different perspectives on monitoring and analyzing the motion of fluids, each with distinct advantages depending on the scenario.
The Eulerian method focuses on fixed points in space where fluid properties, such as velocity, pressure, and temperature, are observed as the fluid moves between these...