3-D Finite element analysis of all-ceramic posterior crowns

The purpose of this study was to evaluate the stress distribution under various loading conditions within posterior all-ceramic crowns. A three-dimensional finite element model representing a lower first molar was constructed. Variations of the model had two types of single layer all-ceramic crowns (Dicor and Empress) and two types of double layer all-ceramic crowns (In-Ceram and Empress2) cemented. A load of 600 N, simulating the maximum bite force, was applied vertically to the crowns. Loads of 225 N, simulating masticatory force, were applied from three directions (vertically, at a 45 degrees angle, and horizontally). In the test simulating maximum bite force, the maximum tensile stresses on all crowns (17.4-19.4 MPa) concentrated around the loading points. In the masticatory force simulation test, the specimens experienced maximum tensile stresses of 19.7-27.0 MPa under a horizontal load and 10.8-10.9 MPa under a vertical load. When the load was applied horizontally, the maximum tensile stress was observed around the loading points on the surface in the case of the single layer crowns, and of the cervical area of the inner core of the double layer crowns. Within the limitation of this study, it was found that the strength of occlusal contact points is important to the integrity of posterior all-ceramic crowns and that bite forces applied from the horizontal direction are a critical factor.