Mechanism of strength increase for a hydrothermal porcelain

The objectives of this study were to verify the formation of a hydrolyzed surface layer on Duceram LFC, to determine the effects of such a layer on mechanical material properties, and to identify a specific mechanism responsible for any strength increase observed.

Specimens were fabricated from dentin porcelain by a vibration blotting technique and were prepared to have either blunt or sharp surface flaws. Half of the specimens underwent accelerated aging. Specimens were fractured in three-point flexure to measure their strength, and fractographic analysis was used to determine fracture toughness and residual surface stress. Surface hardness and elastic modulus were measured using a microindentation method. Porcelain surface topography was examined using atomic force microscopy, and Fourier transform infrared spectroscopy was used to determine the composition of the surface layer.

The aging treatment modified the porcelain surface topography but did not create a layer with increased hydroxyl ion content. Porcelain strength increased upon aging, and the increase was proportional to initial flaw severity. The apparent fracture toughness of sharp flaw specimens increased to match that for specimens containing blunt flaws upon aging. Surface hardness and elastic modulus decreased upon aging.

Previous studies on the strength increase of hydrothermal porcelain were contradictory because a variety of specimen preparation procedures were used. This study resolves the apparent contradiction by determining the effect of specimen preparation on material strength.