The use of glass ionomer as a root canal sealer--a pilot study

The use of a resin-based glass ionomer as an endodontic sealer was studied in vitro. The root canals of extracted single-rooted human teeth with mature apices were prepared using a stepback technique. Subsequently, the smear layer was removed with 40% citric acid and the canals obturated using lateral condensation of cold gutta-percha and a resin-based glass ionomer as the sealer. The relationship between the sealer and the wall of the root canal was studied using scanning electron microscopy. The shear bond strength of gutta-percha to this glass ionomer was also determined. Finally, the uptake of fluoride into the wall of the root canal was studied using scanning electron microprobe analysis after storage for 2 weeks, 1 month and 3 months following root filling with gutta-percha and glass ionomer cement. The results showed that removal of the smear layer allowed the sealer to enter some of the dentinal tubules. This was observed most frequently in the middle third of the root canal, where there was good adaptation of the sealer. The shear bond strength of gutta-percha to the glass ionomer sealer was not significantly different from that obtained between gutta-percha and a proprietary zinc oxide-eugenol endodontic sealer. The concentration of fluoride in the dentine in the coronal part of the root canal increased after obturation with gutta-percha and the glass ionomer sealer at every time interval. The increase in fluoride concentration varied widely between teeth. It is concluded that a resin-based glass ionomer cement may have potential as a root canal sealer.