Related Experiment Video
Updated: Aug 7, 2026

Soil Lysimeter Excavation for Coupled Hydrological, Geochemical, and Microbiological Investigations
Published on: September 11, 2016
RDX loss in a surface soil under saturated and well drained conditions
D B Ringelberg1, C M Reynolds, M E Walsh
1U.S. Army ERDC-CRREL, 72 Lyme Rd., Hanover, NH 03755, USA. David.B.Ringelberg@erdc.usace.army.mil
Abstract:
On military training ranges, low-order, incomplete detonations deposit RDX (hexahydro-1,3,5-trinitro-1,3,5-triazine) into surface soils. In this study, we evaluated RDX biodegradation in surface soils obtained from a military training range in Alaska. Two factors were compared: (i) soil water potential during the incubations; and (ii) the use of acetonitrile (ACN) as an RDX carrier to spike samples. Organic solvents have been used in laboratory studies to dissolve slightly water-soluble contaminants before addition to soil. We added ACN to obtain final soil ACN concentrations of 0 mg kg(-1) (0%), 1000 mg kg(-1) (0.1%) and 10 000 mg kg(-1) (1%). We then compared RDX attenuation in the soil under saturated and unsaturated conditions. RDX fell below the limit of detection within 3 wk of study initiation under the saturated condition. A maximum degradation rate of 0.15 mg RDX L(-1) d(-1) was measured. Under the unsaturated condition, 42% of the original RDX was still present at study termination (5 wk). The addition of acetonitrile at 0.1 or 1.0% had no affect on RDX loss in the saturated soil. In the unsaturated soil, however, ACN at 1.0% inhibited RDX loss by as much as 25%. These findings indicate that soil water potential and carrier solvent concentrations can impact the rate and extent to which RDX is attenuated in a surface soil.
Related Concept Videos
Responses to Drought and Flooding
Porosity and Absorption of Aggregate
When all pores in an aggregate are filled with water, the aggregate is considered saturated and surface-dry. If left in dry air, water will evaporate until the aggregate...
Drying Shrinkage
A portion of this drying shrinkage can be reversed; if the concrete is...
Response Surface Methodology
The process of RSM involves several key steps:
Major Losses in Pipes
Fluid flow can be classified as laminar or turbulent, primarily based on the Reynolds number. This dimensionless number reflects the relative influence of inertial to viscous...
Design Example: Design of an Irrigation Channel

