Related Experiment Video

Updated: Sep 20, 2026

Determination of Inorganic Arsenic in a Wide Range of Food Matrices using Hydride Generation - Atomic Absorption Spectrometry.

Determination of Inorganic Arsenic in a Wide Range of Food Matrices using Hydride Generation - Atomic Absorption Spectrometry.

Published on: September 1, 2017

[Direct determination of selenium and bismuth in antimony and antimony compound by hydride generation-atomic

Z X Li¹, K Y Tong, X W Guo

¹Northwest Nonferrous Geological Research Institute, Xian 710054, China.

Guang Pu Xue Yu Guang Pu Fen Xi = Guang Pu

|August 30, 2003

Abstract:

The interference of Sb in determination of Se and Bi in antimony powder and antimony compound has been studied in different acidity, it is found that the interference of antimony has been reduced apparently in high acidity. Simultaneously, according to the difference of hydride generation reaction between Sb5+ and Sb3+, a sensitive and rapid method has been developed and used to determine Se and Bi in real samples. The recovery of the method is 95%-105% for practical samples. Detection limits are 0.00004 x 10(-2) (content) for Se and 0.0001 x 10(-2) mg.L-1 (content) for Bi respectively. The relative standard deviations of Se are 2.4% (content = 0.00169 x 10(-2) mg.L-1) and 5.4% (content = 0.00056 x 10(-2) mg.L-1). The relative standard deviations of Bi are 5.0% (content = 0.00024 x 10(-2) mg.L-1) and 1.3% (content = 0.00229 x 10(-2) mg.L-1). The method has been applied to determination of Se and Bi in practical samples with satisfactory results.

More Related Videos

Biological Samples Preparation for Speciation at Cryogenic Temperature using High-Resolution X-Ray Absorption Spectroscopy

Biological Samples Preparation for Speciation at Cryogenic Temperature using High-Resolution X-Ray Absorption Spectroscopy

Published on: May 27, 2022

A Dual-Functional Electroactive Filter Towards Simultaneously Sb(III) Oxidation and Sequestration

A Dual-Functional Electroactive Filter Towards Simultaneously Sb(III) Oxidation and Sequestration

Published on: December 5, 2019

Related Concept Videos

Atomic Absorption Spectroscopy: Atomization Methods

Atomic Absorption Spectroscopy: Atomization Methods

Atomic Absorption Spectroscopy (AAS) atomizes samples through flame atomization or electrothermal atomization. Flame atomization typically involves a nebulizer and spray chamber assembly to combine the sample with a fuel–oxidant mixture, creating a fine aerosol mist that enters a burner. Typically, the fuel and oxidant are combined in an approximately stoichiometric ratio. However, for atoms that are easily oxidized, a fuel-rich mixture may be more advantageous. Only about 5% of the aerosol...

Atomic Fluorescence Spectroscopy

Atomic Fluorescence Spectroscopy

Atomic fluorescence spectroscopy (AFS) is an analytical technique that involves the electronic transitions of atoms in a flame, furnace, or plasma being excited by electromagnetic (EM) radiation. When these atoms absorb energy, they become excited and subsequently release energy as they return to their original state. This emitted light, or "fluorescence," is observed at a right angle to the incident beam. Both absorption and emission processes transpire at distinct wavelengths, which are...

Atomic Absorption Spectroscopy: Lab

Atomic Absorption Spectroscopy: Lab

For AAS measurements, samples must be introduced as clear solutions, often requiring extensive preliminary treatment to dissolve materials like soils, animal tissues, and minerals. Common methods for sample preparation include treatment with hot mineral acids, wet ashing, combustion in closed containers, high-temperature ashing, or fusion with reagents.
Solutions containing organic solvents, such as low-molecular-mass alcohols, esters, or ketones, enhance absorbances by increasing nebulizer...

Atomic Emission Spectroscopy: Lab

Atomic Emission Spectroscopy: Lab

AES is a powerful analytical technique, especially effective when used with plasma sources, producing abundant spectra in characteristic emission lines. The Inductively Coupled Plasma (ICP), in particular, yields superior quantitative analytical data due to its high stability, low noise, low background, and minimal interferences under optimal experimental conditions. However, newer air-operated microwave sources are emerging as promising alternatives that could be more cost-effective than...

Atomic Emission Spectroscopy: Instrumentation

Atomic Emission Spectroscopy: Instrumentation

The instrumentation of atomic emission spectrometry (AES) involves various components, including atomization devices that convert samples into gas-phase atoms and ions. There are two main types of atomization devices: continuous and discrete atomizers. Continuous atomizers, like plasmas and flames, introduce samples in a constant stream, while discrete atomizers inject individual samples using syringes or autosamplers. The most common discrete atomizer is the electrothermal atomizer.

Precipitation of Ions

Precipitation of Ions

Predicting Precipitation
The equation that describes the equilibrium between solid calcium carbonate and its solvated ions is:

Articles linked to this work by shared authors, journal, and citation graph.

First Experimental Constraint on the Scalar Current in the D^{0(+)}→K[over ¯]ℓ^{+}ν_{ℓ} Transition.

Physical review letters·2026

First Observation of D^{0(+)}→K[over ¯]ωe^{+}ν_{e} and Determination of the Branching Fraction of K[over ¯]_{1}(1270)→K[over ¯]ω.

Physical review letters·2026

Measurements of the Absolute Branching Fraction of the Semileptonic Decay Ξ^{-}→Λe^{-}ν[over ¯]_{e} and the Axial Charge of Ξ^{-}.

Physical review letters·2026

First Measurement of the Absolute Branching Fraction of η_{c}→γγ.

Physical review letters·2026

Study of the Reactions n[over ¯]p→2π^{+}π^{-}, 2π^{+}π^{-}π^{0}, and 2π^{+}π^{-}2π^{0} Using J/ψ→pπ^{-}n[over ¯].

Physical review letters·2026

Search for Sub-GeV Dark Particles in η→π^{0}+Invisible Decay.

Physical review letters·2026

See all related articles