Related Experiment Videos

Selection of a minimum-boundary reserve network using integer programming

Hayri Onal1, Robert A Briers

  • 1Department of Agricultural and Consumer Economics, University of Illinois at Urbana-Champaign, Urbana, IL 61801, USA. h-onal@uiuc.edu

Related Concept Videos

Design Example: Alignment of a Road Line Using GIS01:17

Design Example: Alignment of a Road Line Using GIS

The alignment of a road line using Geographic Information Systems (GIS) is a critical process in civil engineering, combining advanced technology with practical decision-making. This methodology begins with the collection of geospatial data, including information on land cover, geomorphology, drainage patterns, slope, and contour details. Such data is typically acquired through satellite imagery and GIS tools, offering a comprehensive understanding of the terrain.Once the data is gathered, it...
Lagrange Multipliers: Two Constraints01:28

Lagrange Multipliers: Two Constraints

The method of Lagrange multipliers with two constraints is used to optimize a function subject to two independent constraints. In many applications, the objective function represents a quantity to be maximized or minimized, such as cost, area, distance, or energy. The two constraints represent requirements that the solution must satisfy, such as fixed volume, limited resources, or prescribed dimensions.For a function of three variables, each constraint forms a surface in three-dimensional space.
Introduction to Nonlinear Inequalities01:25

Introduction to Nonlinear Inequalities

Linear and nonlinear inequalities are fundamental for analyzing variable relationships and identifying ranges satisfying specific conditions. A linear inequality involves variables raised only to the first power, resulting in a straight-line graph. This line partitions the coordinate plane into two distinct regions: one that satisfies the inequality and one that does not. Each region represents a set of solutions where the linear relationship holds true under the specified constraint.Nonlinear...
Boundary Conditions: Lossless Lines01:21

Boundary Conditions: Lossless Lines

Consider a single-phase, two-wire, lossless transmission line terminated by an impedance at the receiving end and a source with Thevenin voltage and impedance at the sending end. The line, with length, has a surge impedance and wave velocity determined by the line's inductance and capacitance.
At the receiving end, the boundary condition states that the voltage equals the product of the receiving-end impedance and current. This relationship is expressed as a function of the incident and...
Area Between Curves: Problem Solving01:28

Area Between Curves: Problem Solving

A region can be enclosed by three curves: a square root function, a reflected cube root function, and a linear function. The linear function intersects each of the other two curves, and these intersection points determine where the boundary of the enclosed region changes. Because different curves serve as the upper and lower boundaries in different parts of the graph, the area cannot be found using a single setup over the entire interval.To compute the area, the region is first divided into two...
Optimization Problems01:26

Optimization Problems

Optimization problems often involve identifying maximum or minimum values under specific constraints. A well-known example is determining the longest horizontal pipe that can be moved around a right-angled corner, where a 3-meter-wide hallway meets a 2-meter-wide hallway. This scenario, common in architectural design and industrial transport, can be understood conceptually through geometric and trigonometric reasoning.To visualize the problem, consider the pipe as a straight line that touches...