[Comparison of the stress distribution with bone density in the spine]
1Changzheng Hospital, Shanghai.
Zhonghua Wai Ke Za Zhi [Chinese Journal of Surgery]
|August 1, 1992
Abstract:
The results of study on stress distribution of the lumbar spine analyzed with a mechanical model of the lumbar motion segment constructed by a three-dimensional finite element method, and the comparison of resulting values with the corresponding bone density represented by the attenuation value of CT were reported. The results indicated that the stress levels in various parts of the lumbar spine were closely related to the CT values. The authors conclude that the mechanical stress is an important factor in maintaining the dynamic balance of bone growth.
Related Concept Videos
01:29Blood and Nerve Supply to the Bones
Bones are dynamic organs that require a rich supply of oxygen and nutrients. Around 5% to 10% of the cardiac output supplies blood to the bones. A typical long bone has three main sources: the nutrient artery, the metaphyseal and epiphyseal arteries, and the periosteal arteries.
Nutrient Artery
The nutrient artery is the main blood vessel that enters the diaphysis via the nutrient foramen. While most long bones have only one nutrient foramen, large bones, such as the femur, may have two. This...
Nutrient Artery
The nutrient artery is the main blood vessel that enters the diaphysis via the nutrient foramen. While most long bones have only one nutrient foramen, large bones, such as the femur, may have two. This...
01:15Stress: General Loading Conditions
To grasp the intricacy of real-world conditions where multiple loads are applied simultaneously to a structure, one might visualize a section passing through a specific point within a body, aligned parallel to the xy plane. This section is subjected to various forces, including original loads, normal forces, and shearing forces.
The shearing force, possessing potential directionality within the plane of the section, is simplified into two component forces running parallel to the x and y axes.
The shearing force, possessing potential directionality within the plane of the section, is simplified into two component forces running parallel to the x and y axes.
01:24Stress Concentrations
Stress concentration is when stress intensifies near discontinuities such as holes or abrupt cross-sectional changes in a structural member. This localized stress can often surpass the average stress within the member. The stress distribution in flat bars, either with a circular hole or varying widths connected by fillets, can be determined experimentally using a photoelastic method. The results are based on ratios of geometric parameters like the ratio of the hole's radius to the smaller width...
01:16Flexural Stress
When analyzing bending in symmetric members, it's crucial to understand how stresses distribute when subjected to bending moments. This stress distribution is effectively described by applying fundamental mechanics and material science principles, particularly Hooke's Law for elastic materials.
Hooke's Law states that within the material's elastic limits, stress is directly proportional to strain. In a member experiencing a bending moment, the strain at any point is relative to its distance...
Hooke's Law states that within the material's elastic limits, stress is directly proportional to strain. In a member experiencing a bending moment, the strain at any point is relative to its distance...
01:13Stress Concentrations
The concept of stress concentration is crucial for understanding how materials respond under bending stresses, particularly when there are irregularities or discontinuities in the material's geometry. Normally, stress in a symmetric member subjected to pure bending is assumed to be uniformly distributed across the entire cross-section. However, this assumption does not hold when there are variations in the cross-sectional geometry or the presence of notches and holes.
The stress concentration...
The stress concentration...
01:11Distribution of Stresses in a Narrow Rectangular Beam
In studying beam stress distribution, examining an elemental section is essential. To determine the average shearing stress on this face, the calculated shear is divided by the surface area. Importantly, shearing stresses on the beam's transverse and horizontal planes mirror each other, indicating a consistent stress distribution along the upper region of the beam. Notably, shearing stresses are absent at the beam's upper and lower surfaces due to the absence of applied forces in these areas.