Effect of biological contamination on dentine bond strength of adhesive resins

The purpose of this in vitro study was to determine the effect of saliva (S) and blood (B) contamination on the dentine bond strength of two single-component dentine bonding systems. The occlusal thirds of 120 recently extracted, human molars were removed with a low speed saw and subsequently embedded in Bencor rings by means of self-curing, acrylic resin. The occlusal surfaces were ground wet on 600-grit silicone carbide paper in a polishing machine to expose superficial dentine and to create a smear layer. The teeth were randomly divided into 12 groups (n = 10). All the dentine surfaces were etched with 34% phosphoric acid for 15 seconds rinsed with water, air-dried for 3 seconds, leaving the surfaces visibly moist. For the control groups (C) the etched dentine surfaces were treated with either, Scotchbond 1 (SB1, 3M) or Prime & Bond NT (PBNT, Dentsply) according to the manufacturer's instructions. In the contaminated groups, the saliva or blood was applied by means of a disposable brush, left undisturbed for 1 minute, and the excess then thinned by air spray. The dentine bonding systems were then applied, also according to manufacturer's instructions. Composite (Z250 and TPH) and Compomer (F2000 and Dyract AP (D-AP)) stubs were packed and cured incrementally to the corresponding pretreated dentine surfaces. All specimens were stored for 24 hours under water at 37 degrees C. The bonds were then stressed to failure with a Zwick testing machine, operating at a crosshead speed of 0.5 mm/min. Fractured samples were examined in a Scanning Electron Microscope. The data were statistically analysed (Student-t test). The mean SBS (MPa) were. SB1 with Z250: C = 19.1 +/- 4.4; S = 17.3 +/- 3.5; B = 2.6 +/- 0.9; SB1 with F2000: C = 11.8 +/- 3.3; S = 9.7 +/- 1.8; B = 4.7 +/- 1.6. PBNT with TPH: C = 9.2 +/- 3.2; S = 6.5 +/- 3.0; B = 4.3 +/- 1.5; PBNT with D-AP: C = 10.2 +/- 3.6; S = 9.3 +/- 2.9 and B = 7.3 +/- 2.5. There was no statistical significant difference in shear bond strengths between the control and the saliva-contaminated samples for both systems. There was, however, a significant difference in bond strengths between the control and the blood-contaminated samples. Blood contamination negatively influenced bond strength of bonding systems to dentine.