Related Experiment Video
Updated: Jun 25, 2026
08:07
Spectrophotometric Determination of Phycobiliprotein Content in Cyanobacterium Synechocystis
Published on: September 11, 2018
C-PHYCOCYANIN: MINIMUM MOLECULAR WEIGHT
Science (New York, N.Y.)
|September 4, 1964
Abstract:
Sedimentation and immunodiffusion experiments indicate that the molecular weight for the minimum molecular unit of C-phycocyanin is 30,000. This result agrees with an analysis of available data on amino acid content for C-phycocyanins from several different algae.
Related Concept Videos
03:37Subatomic Particles
Dalton was only partially correct about the particles that make up matter. All matter is composed of atoms, and atoms are composed of three smaller subatomic particles: protons, neutrons, and electrons. These three particles account for the mass and the charge of an atom.
01:52Atomic Mass
Atoms — and the protons, neutrons, and electrons that compose them — are extremely small. For example, a carbon atom weighs less than 2 × 10−23 g. When describing the properties of tiny objects such as atoms, we use appropriately small units of measure, such as the atomic mass unit (amu). The amu was originally defined based on hydrogen, the lightest element, then later in terms of oxygen. Since 1961, it has been defined with regard to the most abundant isotope of carbon, atoms of which are...
01:01Polymers: Defining Molecular Weight
Unlike small molecules with definite molecular weights, polymers are a mixture of individual polymer chains of varying lengths, each with a unique molecular weight. So, the molecular weight of a polymer is expressed as an average value based on the average size of the polymer chains. The two most common forms of averages used for polymers are the number average molecular weight and weight average molecular weight.
The number average molecular weight (Mn) is the summation of the number...
The number average molecular weight (Mn) is the summation of the number...
01:10Polymers: Molecular Weight Distribution
For any given polymer, the weight average molecular weight (Mw) is higher than, if not equal to, the number average molecular weight (Mn). The only situation in which the weight average molecular weight and the number average molecular weight are equal is when a polymer consists only of chains with equal molecular weight. However, this never happens in a synthetic polymer, since it is difficult to control the polymerization process up to a molecular level with accuracy to a hundred percent.
01:08Molecular Weight of Step-Growth Polymers
Step growth polymerization involves bi or multifunctional monomers. Bifunctional monomers react to form linear step growth polymers, whereas multifunctional monomers react to form non-linear or branched polymers.
As the step-growth polymerization involves step-wise condensation of monomers, the molecular weight also builds up eventually. Consequently, high molecular weight polymers are obtained at the late stages of the polymerization, where 99% of monomers have been consumed.
The extent of the...
As the step-growth polymerization involves step-wise condensation of monomers, the molecular weight also builds up eventually. Consequently, high molecular weight polymers are obtained at the late stages of the polymerization, where 99% of monomers have been consumed.
The extent of the...
01:25Atomic Weight
Protons and neutrons have approximately the same mass, about 1.67 × 10-24 grams. Scientists arbitrarily define this amount of mass as one atomic mass unit (amu) or one Dalton. Electrons are much smaller in mass than protons, weighing only 9.11 × 10-28 grams, or about 1/1800 of an atomic mass unit. As a result, they do not contribute much to an element's overall atomic mass. This means that, when considering atomic mass, it is customary to ignore the mass of any electrons and calculate the...