A practical approach to evaluation of the germicidal efficiency of a general purpose military disinfectant

The bactericidal activity of a general purpose disinfectant consisting of 25% sodium-o-phenylphenolate and 75% sodium-4- and 6-chloro-2-phenylphenolate was evaluated by a simulated in-use, surface-square dilution method. Common floor (asphalt, rubber, and unglazed tiles) and wall (stainless steel tile, ceramic tile, and painted wood) surfaces of various porosities and compositions were selected to simulate actual-use conditions. The method used consisted of inoculating the surfaces of 1-in. square sections of floor and wall covering with a test organism, air-drying the inoculated surface, applying the disinfectant, allowing it to act for 10 min, and recovering the survivors by plating. Confirmatory results of the standard phenol coefficient and use-dilution tests indicated 700 ppm of the disinfectant to be a safe use concentration. The in-use surface-square dilution studies have shown that this is a more than adequate safe concentration for stainless steel, both glazed and unglazed ceramic tile, and nonwaxed surface of asphalt tile. However, concentrations ranging between 2,500 and 6,000 ppm for plastic-fortified rubber tile, 1,500 and 2,000 ppm for waxed asphalt tile, and 2,000 ppm for painted wood were required to achieve 99.9% reduction of either Salmonella choleraesuis or Salmonella schottmuelleri. These results indicate that a disinfectant concentration derived from the Association of Official Agricultural Chemists use-dilution test cannot always be relied upon to provide a dependable index to actual safe use-dilution when a disinfectant is supplied to certain wall or floor surfaces.