Comparison of a new venous control device with a bladder box system for use in ECMO

During extracorporeal membrane oxygenation (ECMO), forward pump flow must not be allowed to exceed the rate of blood drainage from the patient so that excessive negative pressure does not develop within the ECMO circuit or in the patient's right atrium. A distensible reservoir ("bladder") and mechanically actuated electronic switch ("bladder box"), has typically been used for this purpose. If the rate of blood flow from the patient to the pump is insufficient to support the perfusion rate desired and adjustments in volume status and catheter position do not increase blood drainage, the only recourse is to increase the siphon pressure by elevating the patient. At the author's institution, a novel venous control module (VCM), without a reservoir, that can provide increased venous drainage without elevating the patient is used. Using an in vitro model of neonatal ECMO, the authors' compared their VCM to a commercially available "bladder box" system. Pressures were monitored in a collapsible chamber inside a water bath (simulating the right atrium), at the gravitational high point of the ECMO circuit ("neck site") and at the low point of the circuit ("venous site") at flow rates of 100, 450, 900, and 1,300 cc/min. Pump shut-off characteristics for both systems were also measured with either sudden interruption of venous drainage ("cross-clamping") or restriction of venous inflow ("hypovolemia"). Under continuous flow conditions, higher flows could be achieved with the VCM. With acute venous catheter occlusion, instantaneous ("trough") pressures at the neck site were lower, and venous monitoring site pressures were higher with the bladder box system.(ABSTRACT TRUNCATED AT 250 WORDS)