Related Experiment Video
Updated: Aug 31, 2026

Preparation of 6-aminocyclohepta-2,4-dien-1-one Derivatives via Tricarbonyl(tropone)iron
Published on: August 12, 2019
Sonochemical destruction of free and metal-binding ethylenediaminetetraacetic acid
J Aaron Frim1, James F Rathman, Linda K Weavers
1Department of Civil and Environmental Engineering, Ohio State University, 470 Hitchcock Hall 2070 Neil Ave., Columbus, OH 43210, USA.
Abstract:
This study focused on the sonochemical degradation of ethylenediaminetetraacetic acid (EDTA) and chromium-EDTA complexes. Degradation of the copper(II)-EDTA complex was also investigated as a comparison metal complex. A 90% degradation of a 150-microM EDTA solution with continuous O2-bubbling was shown for the 20-kHz system in approximately 3 h (kpseudo-first order = 1.22 x 10(-2) min-1) and less than 1 h for the 354-kHz system (kpseudo-first order = 5.42 x 10(-2) min-1). These results are consistent with the higher concentrations of hydrogen peroxide found in the higher frequency system and an expected oxidation of EDTA in bulk solution. The presence of a chelated metal decreased the rate of degradation at both frequencies. Cr(III)-EDTA degraded the slowest, supporting the theory that the extremely slow ligand exchange rate of chromium is the determining factor in how fast degradation by hydroxyl radical can occur. The 354-kHz system showed a 17% decrease in the original 150-microM Cr(III)-EDTA complex after 3 h of sonication. All of the chromium from the degraded EDTA complex existed as a combination of oxidized Cr(VI) and possibly small amounts of a new Cr(III)-organic complex (Cr(III)-Y). The 20-kHz system showed a similar extent of degradation (16%) after 3 h of sonication, despite lower hydroxyl radical production. Fifty percent of the chromium from the degraded EDTA complex was found as free Cr3+ ion, with the remaining 50% existing as both Cr(III)-Y and Cr(VI). Varying degrees of bulk oxidation, near-bubble thermolysis, and perhaps different degradation pathways at the two frequencies are responsible for these differences.
Related Concept Videos
EDTA: Chemistry and Properties
EDTA: Auxiliary Complexing Reagents
Masking and Demasking Agents
There are many masking agents, such as cyanide, fluoride, triethanolamine, thiourea, and 2,3-bis(sulfanyl)propan-1-ol (formerly 2,3-dimercapto-1-propanol), with the masking agent chosen based on the metal...
EDTA: Direct, Back-, and Displacement Titration
Direct titration involves buffering the metal ion solution to the desired pH and directly titrating with standard EDTA until the endpoint. The optimum pH ensures a large conditional formation constant of metal−EDTA and visibility of the free indicator color in the solution. In addition, auxiliary complexing reagents are used to prevent the precipitation of metal hydroxides and...
EDTA: Indirect and Alkalimetric Titration
Carboxylic Acids to Methylesters: Alkylation using Diazomethane

