Nitrification-denitrification of opto-electronic industrial wastewater by anoxic/aerobic process

This research focused on the biological treatment of high-strength organic nitrogen wastewater, and presented the results from the nitrification and denitrification of an actual industrial wastewater using anoxic/aerobic process. The opto-electronic industrial wastewater often contains a significant quantity of organic nitrogen compounds and has a ratio over 95% in organic nitrogen (Org-N) to total nitrogen (T-N). In this study, a 2-stage anoxic/aerobic process was established and evaluated the efficiency of wastewater treatment. Raw wastewater from an actual TFT-LCD manufacturing plant was obtained as the sample for looking into the feasibility of opto-electronic industrial wastewater treatment. After toxicity identification evaluation (TIE) test of raw wastewater. the inhibition was related to organic nitrogen (TMAH, MEA) and unionized ammonia (free ammonia, NH3) with high pH. Therefore, pH control is important for biological treatment of high-strength organic nitrogen industrial wastewater. Besides. hydraulic retention time (HRT) and mixed liquor recycled rate (MLR) were controlled independently to distinguish between the effects of these two factors. Under suitable HRT ( > 1.7 d) and mixed liquor recycled rate (< 4Q), effluent of NH4-N. NO3-N + NO2-N, and COD can fall below 20 mg/L, 30 mg/L, and 80 mg/L. The anoxic/aerobic process removed 92-98% of the carbon source, and approximately 80% of TKN, 70% of T-N.