Related Experiment Video

Updated: Aug 30, 2026

Effect of Change of Direction (COD) Movement on Plantar Pressure and Foot Balance in Bilateral Limbs
09:24

Effect of Change of Direction (COD) Movement on Plantar Pressure and Foot Balance in Bilateral Limbs

Published on: March 10, 2026

[Calculation of hallux bending moments from plantar pressure distribution measurement]

R Lampe1, J Mitternacht, E Steinhauser

  • 1Gang- und Bewegungsanalyselabor, Klinik für Orthopädie und Sportorthopädie der TU München, Klinikum Rechts der Isar, Munich. renee.lampe@lrz.tu-muenchen.de

Zeitschrift Fur Orthopadie Und Ihre Grenzgebiete
|October 11, 2003
PubMed
Abstract

Related Concept Videos

Flexural Stress01:16

Flexural Stress

When analyzing bending in symmetric members, it's crucial to understand how stresses distribute when subjected to bending moments. This stress distribution is effectively described by applying fundamental mechanics and material science principles, particularly Hooke's Law for elastic materials.
Hooke's Law states that within the material's elastic limits, stress is directly proportional to strain. In a member experiencing a bending moment, the strain at any point is relative to its distance...
Residual Stresses in Bending01:18

Residual Stresses in Bending

In the study of elastoplastic members subjected to bending moments, understanding the loading and unloading phases is crucial for assessing material behavior and structural integrity. During the loading phase, as the bending moment increases, the material initially responds elastically, adhering to Hooke's Law, where stress is directly proportional to strain. When the load exceeds the yield strength, plastic deformation occurs, resulting in permanent strain and deformation that remains even...
Bending Moment Diagram01:30

Bending Moment Diagram

A bending moment diagram is a graphical representation of the bending moments experienced by a beam under load along the beam length. It is an essential tool for engineers and designers to analyze structures and ensure they can withstand applied forces. The steps to create the bending moment diagram for a beam are listed below.
Determine reactive forces and couple moments: Calculate all the reactive forces and couple moments acting on the beam. In certain cases, when the beam is inclined at an...
Problem Solving in Statics01:28

Problem Solving in Statics

Problem-solving in statics is a crucial aspect of engineering and physics that involves resolving issues associated with bodies in a state of equilibrium. In most cases, problem-solving requires several steps to achieve an accurate result. These steps are crucial to ensuring that the solution is accurate and practical.
The physical situation and mathematical modeling must be considered; however, it is challenging to represent all physical situations using mathematical modeling. With the help of...
Bending of Material: Problem Solving01:09

Bending of Material: Problem Solving

In this lesson, determine the ratio of the maximum bending moments applied to two metal pipes, given that both pipes can withstand a maximum stress of 100 MPa. Both pipes have an outer radius of 1.8 cm. Pipe A has an inner radius of 1.5 cm, and Pipe B has an inner radius of 1 cm. The ratio of the maximum bending moment applied to two metallic pipes, each with a different inner and outer radius, is determined by considering their dimensions. The inner radius of the first pipe is 1.5 cm, and for...
Plastic Deformations of Members with a Single Plane of Symmetry01:21

Plastic Deformations of Members with a Single Plane of Symmetry

When a structural member undergoes plastic deformation due to bending, it is crucial to understand the position of the neutral axis and the stress distribution. This member, characterized by a single plane of symmetry, exhibits a uniform stress distribution, with negative stress above the neutral axis and positive stress below. Notably, the neutral axis does not align with the centroid of the cross-section. This misalignment is typical in cases where the cross-section is not rectangular or...