Ultrasound-mediated cavitation thresholds of liquid perfluorocarbon droplets in vitro

This study was undertaken to measure the ultrasound (US)-mediated cavitation threshold of microdroplets as a function of its content and US parameters (frequency, amplitude and burst length). Albumin-coated droplets were prepared with perfluoropropane, perfluorohexane or perfluoromethylcyclohexane contents. The filtered suspensions were diluted to 1:1000 (v) and compared with Optison. The formulations were injected into an acoustically transparent vessel and sonicated with a single focused transducer. The frequencies employed were 0.74, 1.1, 2.18 and 3.3 MHz and the burst length and acoustic pressure were varied. The inertial cavitation threshold for each experiment was monitored through passive acoustic detection. The formation of droplet emulsion of the perfluorocarbon increased the natural boiling point of the perfluorocarbon. However, perfluorocarbon droplets having contents with higher molecular weights and boiling points did not have detectably higher inertial cavitation thresholds and, thus, the droplets do not need to be in a superheated state to be cavitated by US bursts. Therefore, higher boiling point perfluorocarbons should be investigated for this purpose and may prove to be useful for both imaging and therapy. The inertial cavitation threshold of perfluorocarbon droplets increases with frequency, and was approximately 0.7 MPa at 0.74 MHz and 1.75 MPa at 3.3 MHz. Optison, already in a gaseous state, has the lowest cavitation threshold of all formulations studied. Results show that, for the frequencies tested, there is no dependence between inertial cavitation threshold and burst lengths between 20 and 100 ms. As a conclusion, the inertial cavitation threshold of albumin-coated microdroplets of several perfluorocarbons was determined in vitro. The results indicate that the physical properties of these droplets are such that they may be useful for localized US therapies.