Development and validation of a method for analysis of "dioxin-like" PCBs in environmental samples from the steel...

A method, previously used for determination of 2,3,7,8-substituted polychlorinated dibenzo-p-dioxins (PCDDs) and polychlorinated dibenzofurans (PCDFs), has been modified for quantitative analysis of "dioxin-like" polychlorobiphenyls (PCBs) in environmental samples from the steel industry. The existing sample clean-up procedure, involving liquid chromatography on multi-layered silica and Florisil columns, has been extended to include a third chromatography stage on a basic alumina stationary phase. The additional clean-up stage is required for PCB analysis in order to eliminate interferences from relatively large concentrations of saturated cyclic and aliphatic hydrocarbons. Samples were analysed for WHO-12 congeners using high resolution gas chromatography/high resolution mass spectrometry (HRGC/HRMS) and standard solutions of the method US EPA 1668A. Replicate analysis of method blanks revealed background contamination for PCBs 118, 105 and 77, which are generally abundant in ambient air. These contaminants were taken into account using a subtraction method. The entire procedure was validated by replicate analysis (N = 3) of a certified reference sediment. The RSD for each WHO-12 congener was below 15%, 13C12-labelled PCB internal standard recoveries were in the range 70-95%. A waste dust sample collected in the electrostatic precipitator of a UK sinter plant was analysed for determination of PCDD/Fs and WHO-12 PCBs and exhibited a PCDD/F I-TEQ of 148.5 +/- 21.2 ngkg(-1) and a WHO-TEQ of 7.2 +/- 1.5 ngkg(-1). WHO-12 congeners contributed only 4.6% to the overall TEQ and PCB 126 was the major congener contributing to the WHO-TEQ (96%). The contribution to the overall TEQ of the waste dust sample was mainly attributed to PCDF followed by PCDD, which accounted for 86.6% and 8.7% to the overall TEQ, respectively.